ALL IN ONE PAYMENT TERMINAL XCL_WT-50 INSTALLATION GUIDE
1. BEFORE STARTING Open the gate behind the device (Figure 1), and find the power input on the right side of the terminal. Connect the plug from the power adapter into the power input (Figure 2). Plug the power adapter into a 120-volt electrical outlet or into a surge suppressor (recommended) after the power cord is connected to the power adapter. Figure 1 Figure 2 Operating Temperature: 0 °C to 40 °C Modem Speed: V.22bis 2400bps/ V.32bis 14400bps RTC battery spec.
Figure 9 3. LOADING THE PAPER Gently pop the printer cover’s latch to open the cover (Figure 10); then lift the cover. Load a roll of thermal paper (Appleton 1012 recommended) into the printer (Figure 11). Load it so that the print-side of the paper will feed out facing the operator. Close the cover by pressing down evenly on both side tabs, or by pressing on the center of the printer cover. Use the serrated bar to tear off any excess paper. Figure 10 Figure 11 4.
7. INSTALLING THE PRIVACY SHIELD The privacy shield of the WT50 shows as figure 18. We need to tear the tap around the privacy shield (Figure 19), and please stick the privacy shield on around the 15-key keypad (Figure 20). The device, WT50, is compliant with PCI privacy screen design requirement when the detachable privacy shield is installed on the device. Any change to or removal of this privacy shield will cause security concerns.
This equipment complies with Part 68 of the FCC rules and the requirements adopted by the ACTA. On the bottom of this equipment is a label that contains, among other information, a product identifier in the format US: N7KMM01AFD150. If requested, this number must be provided to the telephone company. The REN is used to determine the number of devices that may be connected to a telephone line. Excessive RENs on a telephone line may result in the devices not ringing in response to an incoming call.