User's Manual

First Data Corporation

c/o Tasq Technology

800-835-3362 Ext. 0

http://www.firstdata.com/

Printed in the United States of America.

" Federal Communications Commission (FCC) Statement “

This Equipment has been tested and found to comply with the limits for

a Class A digital device, pursuant to part 15 of the FCC Rules. These

limits are designed to provide reasonable protection against harmful

interference when the equipment is operated in a commercial

environment. This equipment generates, uses, and can radiate radio

frequency energy and, if not installed and used in accordance with the

instruction manual, may cause harmful interference to radio

communications.

Operation of this equipment in a residential area is likely to cause

harmful interference in which case the user will be required to correct

the interference at his own expense.

ORTABLE

ERMINAL

FD-400

NSTALLATION

UIDE

PAGE 1
PORTABLE TERMINAL FD-400 INSTALLATION GUIDE First Data Corporation c/o Tasq Technology 800-835-3362 Ext. 0 http://www.firstdata.com/ Printed in the United States of America. © Copyright 2006 First Data Corporation. All rights reserved. " Federal Communications Commission (FCC) Statement “ This Equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules.
PAGE 2
1. POWER ON TERMINAL There are two holes under a plastic cover on the right side of terminal (Figure 1). Figure 1 Load a roll of paper (Appleton 1012 recommended) into the printer (Figure 6). The print-side of the paper will feed out facing the operator. One is power input; another is a port for devices connected to terminal (Figure 2). Figure 6 Close the cover and tear off any excess paper (Figure 7). (Adapter: LI SHIN INT. / LSE0107A1240: Input: 100-240Vac, 50/60Hz 1A; Output: 12Vdc, 3.
PAGE 3
Federal Communications Commission Notice FCC Radiation Exposure Statement This device complies with part 15 of the FCC Rules. Operation is subject to the foll This equipment complies with FCC radiation exposure limits set forth for an owing two conditions: uncontrolled environment . End users must follow the specific operating (1) This device may not cause harmful interference, and instructions for satisfying RF exposure compliance.