PORTABLE TERMINAL FD-400GT(SL8081) INSTALLATION GUIDE
1. BEFORE STARTING There are two holes under a plastic cover on the left side of terminal (Figure 1). One is a power jack; the other is an USB programmable port (Figure 2). Rechargeable battery is on the back side of terminal (Figure 3). Figure 1 Figure 2 Figure 3 Adapter spec: DELTA_ADP-36JH B Input: 100-240Vac, 50/ 60Hz 1A; Output: 12Vdc, 3A Car Charger: EDAC POWER ELECRONICS CO., LTD. / ED1025 Input: 11-16Vdc, 5A; Output: 12Vdc, 2.
4. USING THE MAGNETIC CARD READER Find the reader slot in the middle of surface. Swipe card through slot from left to right or the opposite direction with stripe lies down and facing the display (Figure 7). Figure 7 5. USING THE CONTACTLESS CARD READER Contactless reader antenna is around the display and PIN pad. It will light up with blue color signal when FD400GT is powered on and that means reader is working normally.
This device complies with RSS-210 of the Industry Canada Rules. Operation is subject to the following two conditions: (1) this device may not cause interference and (2) this device must accept any interference, including interference that may cause undesired operation of the device Ce dispositif est conforme à la norme CNR-210 d'Industrie Canada applicable aux appareils radio exempts de licence.
