User's Manual

XAC Automation Corporation

886-3-577-2738

www.xac.com.tw

The above information is the exclusive intellectual property of XAC Automation Corporation

and shall not be disclosed, distributed or reproduced without permission of XAC Automation

Corporation.

XAC AUTOMATION CORP. shall not be held liable for technical and editorial omissions or

errors made herein; nor for incidental or consequential damages resulting from the furnishing,

performance or use of his material.

This document contains proprietary information protected by copyright. All rights are reserve.

ORTABLE TERMINAL

FD-400GT-CDMA

INSTALLATION GUIDE



PAGE 1
PORTABLE TERMINAL FD-400GT-CDMA INSTALLATION GUIDE XAC Automation Corporation 886-3-577-2738 www.xac.com.tw The above information is the exclusive intellectual property of XAC Automation Corporation and shall not be disclosed, distributed or reproduced without permission of XAC Automation Corporation. XAC AUTOMATION CORP.
PAGE 2
1. BEFORE STARTING There are two holes under a plastic cover on the left side of terminal (Figure 1). One is a power jack; the other is an USB programmable port (Figure 2). Rechargeable battery is on the back side of terminal (Figure 3). Adapter spec: DELTA_ADP-36JH B Input: 100-240Vac, 50/60Hz 1A; Output: 12Vdc, 3A Car Charger: EDAC POWER ELECRONICS CO., LTD. / ED1025 Input: 11-16Vdc, 5A; Output: 12Vdc, 2.5A o o Operating Temperature: 0 C to 40 C Battery pack: CHENG UEI / FD400 7.4V, 2.
PAGE 3
4. USING THE MAGNETIC CARD READER Figure 7 Find the reader slot in the middle of surface. Swipe card through slot from left to right or the opposite direction with stripe lies down and facing the display (Figure 7). 5. USING THE CONTACTLESS CARD READER Contactless reader antenna is around the display and PIN pad. It will light up with blue color signal when FD400GT is powered on and that means reader is working normally.