User's Manual

ManualsBrandsXAC Automation ManualsElectronicsPortable Terminal

Federal Communications Commission (FCC)

Statement

This Equipment has been tested and found to comply with

the limits for a Class B digital device, pursuant to part 15

of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference when

the equipment is operated in a commercial environment.

This equipment generates, uses, and can radiate radio

frequency energy and, if not installed and used in

accordance with the instruction manual, may cause

harmful interference to radio communication.

Operation of this equipment in a residential area is likely

to cause harmful interference in which case the user will be

required to correct the interference at his own expense.

First Data Corporation

c/o Tasq Technology

http://www.firstdata.com/

Printed in the United States of America.

FIRST DATA CORPORATION

ORTABLE TERMINAL

FD-400

eTi

NSTALLATION GUIDE

 Visual shields designed into the check-stand.

 Position the PED so that it is angled in such a way

to make PIN spying difficult.

B. Pop-up (temporary) privacy shield attached to the PED

mounting stand. Consumers (through education &

prompting) or merchant would put the shield in place

during PIN entry.

C. Installing PED on an adjustable stand that allows

consumers to swivel the terminal sideways and/or tilt

it forwards/backwards to a position that makes visual

observation of the PIN-entry process difficult process

infeasible.

 Visual shields designed into the check-stand.

 Position the PED so that it is angled in such a way

to make PIN spying difficult.

D. Positioning of in-store security cameras such that the

PIN-entry keypad is not visible. Instructing the

cardholder regarding safe PIN-entry, done with a

combination of:

 Signage on the PED.

 Prompts on the display, possibly with a

"click-through" screen.

 Potentially literature at the point of sale.

 A logo for safe PIN-entry process.

Caution: Risk of explosion if the battery

is replaced by an incorrect type. Please

dispose used battery according to the

local regulations.

“Caution: For continued protection

against fire, replace only with same type

same rating fuse.” Marking is located on

the enclosure of cigarette lighter plug or

located on the input cable near cigarette

lighter plug. Fuse rating (voltage and

ampere) shall also be marked on the

enclosure of cigarette lighter plug near

the fuse.

Caution: For hand held operation, this

terminal will keep away 20cm from the

body in order to meet the FCC RF

exposure guidelines.

LOADING THE PAPER

Pop the printer cover’s latch to open the

cover (Figure 5); then lift the cover. Load

a roll of paper (Appleton 1012 is

recommended) into the printer (Figure

6). The print-side of the paper will feed

out facing the operator.

Close the cover and tear off any excess

paper (Figure 7). The printer is now

ready to use.

Figure 5

Figure 6

Figure 7

5 2

Summary of content (3 pages)

PAGE 1
Federal Communications Commission (FCC) Statement This Equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment.
PAGE 2
Table A1: Matrix of Observation Corridors and PIN Protection Methods POWER ON TERMINAL There are two connections under a plastic cover on the left side of terminal (Figure 1). The bottom is power input; the other is a USB port for devices to connect to terminal (Figure 2). Adapter spec: LI SHIN INT. / LSE0107A1240 Input: 100-240Vac, 50/60Hz 1A Output: 12Vdc, 3.33A Figure 1 Figure 2 Operating Temperature: 0oC to 40oC Battery pack: CHENG UEI / FD-400 7.4V, 2.
PAGE 3
Federal Communications Commission Notice This device complies with part 15 of the FCC Rules. Operation is subject to the foll owing two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that m ay cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B d igital device, pursuant to Part 15 of the FCC Rules.