User Manual

Warning:

A shielded-type power cord is required in order to meet FCC emission

limits and also to prevent interference to the nearby radio and television

reception. It is essential that only the supplied power cord be used.

Use only shielded signal cables to connect I/O devices to this

equipment.

You are cautioned that changes or modifications not expressly

approved by the party responsible for compliance could void your

authority to operate the equipment."

First Data Corporation

c/o Tasq Technology

800-835-3362 Ext. 0

http://www.firstdata.com/

Printed in the United States of America.

ORTABLE TERMINAL

FD-400

NSTALLATION GUIDE

PAGE 1
Warning: A shielded-type power cord is required in order to meet FCC emission limits and also to prevent interference to the nearby radio and television reception. It is essential that only the supplied power cord be used. Use only shielded signal cables to connect I/O devices to this equipment. You are cautioned that changes or modifications not expressly approved by the party responsible for compliance could void your authority to operate the equipment.
PAGE 2
3. USING THE CARD READER 1. POWER ON TERMINAL There are two holes under a plastic cover on the right side of terminal (Figure 1). Figure 1 One is power input, another is a port for devices connected to terminal (Figure 2). (Adapter Input: 100-240V, 50/60Hz 1A; Output: 12V, 3.33A) Rechargeable battery is on the back side of terminal (Figure 3). (Lithium ion battery pack: 7.4V, 2.2A) Figure 8 Find the reader slot on the bottom. Insert smart card into slot with IC chip to face up (Figure 9).
PAGE 3
Federal Communications Commission Notice FCC Radiation Exposure Statement This device complies with part 15 of the FCC Rules. Operation is subject to the foll This equipment complies with FCC radiation exposure limits set forth for an owing two conditions: uncontrolled environment . End users must follow the specific operating (1) This device may not cause harmful interference, and instructions for satisfying RF exposure compliance.