User's Manual

ManualsBrandsXAC Automation ManualsElectronicsHandheld PINpad

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)

This device may not cause harmful interference, and (2) this device must accept any interference received,

including interference that may cause undesired operation.

Warning:

If the device, FD-35, FD-35-ZKA is used without the detachable privacy shield, the

following criteria needs to be met by the Installed Environment of the PED for complying with

the PCI privacy screen design requirement:

A. Positioning of the PED on the check-stand in such way as to make visual observation of the

PIN-entry process infeasible.

 Visual shields designed into the check-stand.

 Position the PED so that it is angled in such a way to make PIN spying difficult.

B. Pop-up (temporary) privacy shield attached to the PED mounting stand. Consumer (through

education & prompting) or merchant would put the shield in place during PIN entry.

C. Installing PED on an adjustable stand that allows consumers to swivel the terminal sideways

and/or tilt it forwards/backwards to a position that makes visual observation of the PIN-

entry process difficult.

D. Positioning of in-store security cameras such that the PIN-entry keypad is not visible.

Instructing the cardholder regarding safe PIN-entry, done with a combination of:

 Signage on the PED.

 Prompts on the display, possibly with a "click-through" screen.

 Potentially literature at the point of sale.

 A logo for safe PIN-entry process.

Table A1: Matrix of Observation Corridors and PIN Protection Method

Observation Corridors

Method Cashier

Customers

in Queue

Customers

Elsewhere

On-Site

Cameras

Remote

Cameras

PED Stand A M H L L L

PED Stand B H H H L M

Check-Stand A L M M L H

Check-Stand B H H M H H

Customer Instruction H* H* H* H* H*

z Customer Instruction methods are less repeatable and therefore should be used in combination

with other methods. L = low, M = medium, H = high.

XAC Automation Corporation

886-3-577-2738

www.xac.com.tw

The above information is the exclusive intellectual property of XAC Automation Corporation

and shall not be disclosed, distributed or reproduced without permission of XAC Automation

Corporation.

XAC AUTOMATION CORP. shall not be held liable for technical and editorial omissions or

errors made herein; nor for incidental or consequential damages resulting from the furnishing,

performance or use of his material.

This document contains proprietary information protected by copyright. All rights are reserve.

FD-35, FD-35-ZKA

PAD

INSTALLATION GUIDE

Summary of content (2 pages)

PAGE 1
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Warning: If the device, FD-35, FD-35-ZKA is used without the detachable privacy shield, the following criteria needs to be met by the Installed Environment of the PED for complying with the PCI privacy screen design requirement: A.
PAGE 2
1. CONNECTING THE FD35 PIN PAD The FD-35, FD-35-ZKA device can be used to connect with PC/ terminal. It supports RJ12 offset, USB interfaces via different cable types such as RJ12 offset and standard USB via mini din (Figure 1) type connector. Note: Turn off or unplug the terminal/PC whenever you connect or disconnect the PIN Pad. Be sure the terminal/PC is not processing data when powering down. 5. CONTACTLESS READER Figure 1 6.