ALL IN ONE PAYMENT A TE ERMINAL FD D130DUO INSTTALLATIO ON GUIDE E
1. BEFORE STARTING Open the gate behind the device (Figure 1), and find the power input on the right side of the terminal. Connect the plug from the power adapter into the power input (Figure 2). Plug the power adapter into a 120-volt electrical outlet or into a surge suppressor (recommended) after the power cord is connected to the power adapter. Figure 1 Figure 2 Operating Temperature: 0 °C to 40 °C Modem Speed: V.22bis 2400bps/ V.32bis 14400bps RTC battery spec.
Figure 9 3. LOADING THE PAPER Gently pop the printer cover’s latch to open the cover (Figure 10); then lift the cover. Load a roll of thermal paper (Appleton 1012 recommended) into the printer (Figure 11). Load it so that the print-side of the paper will feed out facing the operator. Close the cover by pressing down evenly on both side tabs, or by pressing on the center of the printer cover. Use the serrated bar to tear off any excess paper. Figure 10 Figure 11 4.
Figure 15 Figure 16 7. INSTALLING THE PRIVACY SHIELD The privacy shield of the FD130 is shown as figure 17. To install, place the privacy shield over the terminal and hook the top hooks to the device basins beside keypad number 1 and 3. Whilst hooked on, apply pressure to the bottom part of the shield so that it clicks into the bottom hooks shown on figure 18. Figure 19 shows the completion of the privacy shield installation.
Cet equipement est conforme aux limites d'exposition aux rayonnements IC etablies pour un environnement non controle. Cet equipement doit etre installe et utilise avec un minimum de 20 cm de distance entre la source de rayonnement et votre corps. FCC REQUIREM ENTS This equipment complies with Part 68 of FCC Rules. On the base unit of this equipment is a label that contains, among other information, the FCC Registration Number and Ringer Equivalence Number (REN) for this equipment.