d CHIP AND PIN MOBILE PAYMENT DEVICE XCE_E25C / XCE-25-C INSTALLATION GUIDE
1. BEFORE STARTING On the top of xCE_E25C (also called xCE-25-C), there is a micro USB port and reset pin hole (Figure 1) covered under the protection cover (Figure 2); this port is used for battery charging, debugging, firmware update and key injection. NOTE: The battery of xCE_E25C is built-in and rechargeable. Figure 1 Figure 2 o o Operating Temperature: 0 C to 40 C Battery Pack: 3.7V, 1050mAh Input: 5V, 500mA 2.
through the slot with magnetic stripe side facing the same direction as the keypad (Figure 5). Figure 4 Figure 5 5. USING THE IC CARD READER Find the IC card reader slot on the bottom of the device (Figure 6). Insert an IC card into the slot with the chip side facing the same direction as the keypad (Figure 7). Figure 6 Figure 7 6. USING THE CONTACTLESS CARD READER Place the contactless card on top of the contactless logo (Figure 8). Figure 8 7.
Note:This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications.