d CLOUD POS PAYMENT DEVICE XCL_E200CP SERIES INSTALLATION GUIDE
1.
Figure 2 LEFT SIDE 9 SAM Card Slot 10 Audio Jack 11 Buzzer F Figure 3 REAR SIDE 7 Ethernet Port 8 USB Host Port 9 Cash Draw Port 10 USB Type C Device Port 11 12V DC Power Jack
Figure 4 REAR SIDE 12 Speaker 13 Stand Mounting Holes ■ Power Adapter spec: Input: 100 ~240 AC Output: 12V DC (Use only the AC adapter approved and provided by XAC Automation Corporation for use with this device.
2. USING THE MAGNETIC CARD READER Swipe the card through the slot with magnetic stripe side facing the same direction as the display. Figure 5 3. USING THE IC CARD READER Insert an IC card into the slot (Figure 6) with the chip side facing the same direction as the touch panel Figure 6 4.
Tap the contactless card on top of the contactless logo Figure 7 5. HOW TO INSERT SAM Insert an SAM card into the slot (Figure 8) with the chip side facing Figure 8 6.
Take the screw out (1) and then pull out the SAM cover (2) Figure 9 7.
CAUTION: RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE. DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS. The IO & SAM covers provide for SAM card and I/O port installation Removal Warning: When removing the screw of SAM cover and the IO,SAM covers for the purposes of SAM card and I/O port installation, remember to put back the cover and the screw before power on the POS. FEDERAL COMMUNICATION COMMISSION INTERFERENCE STATEMENT This device complies with Part 15 of the FCC Rules.