CONTACTLESS READER MODULE C150 INSTALLATION GUIDE
1. IN THE BOX C150 (Figure 1) with USB, RS232 and custom cable If it’s a RS232 cable, the power jack is on the rear of the DB9 connector. Connect the power cord of the adaptor with the power jack on the rear of the cable (Figure 2) If it’s a USB cable (Figure 3), it will get the power from USB connected Host If it’s a custom cable (Figure 4), it will get the power from custom’s device. Figure 1 Figure 2 Figure 3 Figure 4 2.
CAUTIONS AND W ARNINGS Risk of explosion if the battery is replaced by an incorrect type. Dispose of used batteries according to the instructions. FEDERAL COM M UNICATION COM M ISSION INTERFERENCE STATEMENT This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
XAC Automation Corporation 886-3-577-2738 www.xac.com.tw The above information is the exclusive intellectual property of XAC Automation Corporation and shall not be disclosed, distributed or reproduced without permission of XAC Automation Corporation. XAC AUTOMATION CORP. shall not be held liable for technical and editorial omissions or errors made herein; nor for incidental or consequential damages resulting from the furnishing, performance or use of his material.