"4-IN-1” EMV L1 & L2 PIN PAD INSTALLATION GUIDE 8006L2-3CR QR Code Reader
1. 2 IN 1 CABLE INTRODUCTION There are two model of communication interface for 8006L2-3CR w/ QR code reader: USB interface cable, RS232 interface cable. ¾ 2 in 1 USB 2.0 plug with Micro USB jack USB 2.0 plug is mainly used to connect the device to PC for ActiveSync (Figure 1) while micro USB jack is for power supply (Figure 3).
magnetic stripe and slide the card again. (Figure 7) ¾ Smart Card Reader Find the card reader slot on bottom of PIN Pad. Please insert the card completely and make sure that it cannot be moved forward anymore. If inserted failed, check the position of the card and insert the card again. (Figure 8) Figure 7 Figure 8 5. USING THE QR CODE READER There is a QR Code Reader which is used to scan QR code on the top of the terminal (Figure 9). Target the QR code at the QR code camera (Figure 10).
Note: Do not try to service, repair or adjust the PIN Pad device in any other way; doing so will void your warranty. You are cautioned that changes or modifications not expressly approved by the party responsible for compliance could void your authority to operate the equipment. W arning: This is a Class A product. In a domestic environment this product may cause radio interference in which case the user may be required to take adequate measures.