94m SECURE CLOUD POS TERMINAL XCE_E200I SERIES INSTALLATION GUIDE xCE_200I series: - xCE_E200I-15YXF, xCE_E200I-15NXF, xCE_E200I-15YXX, xCE_E200I-15NXX - xCE_E200I-10YXF, xCE_E200I-10NXF, xCE_E200I-10YXX, 1 xCE_E200I-10NXX
1. Package Content To check your device and the accessories after unpacking: xCE_E200I Power adaptor & cord Cash Drawer cable 2. Before Starting A. Open the cable compartment cover behind the stand of terminal and find the power input on the rear side of xCE_E200I (Figure 1, marked by red circle).
Optional ports (marked by blue square) - 1 x RJ-11 (Modem) port - 1 x RJ-12 COM port Other ports on the side face of screen (Figure 1-1) (Figure 1-1) - 1 x Micro SD card slot - 1 x USB Device (Micro USB) port - 1 x Micro SD card slot Note: A “click” sound should be heard when the micro SD card has been inserted properly. Other features on E200-I: - Camera for customer facing (Optional, as Figure 1-1) - Wireless communication built-in: Wi-Fi (802.11 b/g/n) & Bluetooth. B.
3. Powering On Terminal Plug the power adaptor connector into the power jack of E200-1(as shown in Figure 1) and plug the power cord into a surge suppressor (recommended) or a wall socket to boot up the device. 4. Using Magnetic Card Reader Secure Magnetic Card Reader is located at the right side of terminal. Slide the card in either direction through the slot at even speed.
. Customer facing display (Optional) xCE_200I provides a 5” shopper display as option for the clients to see the payment amount and the information or the ads at the cashier. (Figure 3) (Figure 3) 6. Fitting the view angle of display The design of xCE_E200I stand is flexible for each user to find his/her best view angle to operate the touch display.
7. Guidelines to properly CLEAN your LCD screens Turn your display off and allow it to cool. Make sure your cloth is clean and free of any grit before starting. Spray a liberal amount of the cleaning solution onto one portion of the cloth Using light pressure, wipe the screen to evenly distribute the solution on the screen. Rotating the cloth to a dry portion, wipe the screen until it is dry. You may need to rotate the cloth a second time. Always use light wiping pressure.
FCC for Part15B: Federal Communication Commission Interference Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules.
The REN is used to determine the number of devices that may be connected to a telephone line. Excessive RENs on a telephone line may result in the devices not ringing in response to an incoming call. In most but not all areas, the sum of RENs should not exceed five (5.0). To be certain of the number of devices that may be connected to a line, as determined by the total RENs, contact the local telephone company.
