Safety Instructions

ManualsBrandsX-Sense ManualsElectronicsRemote Controller

RC01 Remote Controller

Manual

Thank you for purchasing this product. To ensure proper use and trouble-free operation, please

read this manual carefully and store it in a safe place for future reference.

Introduction

The RC01 is a dedicated remote controller for the X-Sense wireless interlinked alarms. It easily

controls the paired smoke alarms, sparing users the effort of straining and reaching up to the

ceiling for alarm testing and silencing.

Note: The X-Sense wireless interlinked alarms are not included in the package. Please purchase

them individually.

Important Safety Instructions and Guidelines

Do not hold the test button for an extended period of time or press repeatedly.

Do not modify this device under any circumstances.

Only use the batteries specified and be sure to match the polarity marking.

Package Contents

1 × Remote Controller (Battery Included)

1 × Adhesive Tape

1 × Key

2 × Screw

2 × Anchor Plug

1 × Manual

Summary of content (5 pages)

PAGE 1
RC01 Remote Controller Manual Thank you for purchasing this product. To ensure proper use and trouble-free operation, please read this manual carefully and store it in a safe place for future reference. Introduction The RC01 is a dedicated remote controller for the X-Sense wireless interlinked alarms. It easily controls the paired smoke alarms, sparing users the effort of straining and reaching up to the ceiling for alarm testing and silencing.
PAGE 2
Product Overview 1. LED Indicator 2. Test/Silence Button 3. Rear Cover 4. Battery Operating Instructions Battery Installation Open the rear cover by inserting the included key into the notch at the bottom of the remote controller’sbackside and pry open. Peel off the insulating film on the button cell.Ensure the correct polarity of the batteryand close the cover. Pair Remote Control with the X-Sense Wireless Interlinked Alarm 1. Choose one alarm out of the interconnected alarms.
PAGE 3
turn off in about 3 seconds, indicating that the controller has exited pairing. The alarm in the pairing mode will beep once and automatically enter standby mode. Test the Wireless Connection Between Alarms 4. Hold the test button while within wireless range. The LED indicatoron the remote controller will flash. 5. After the alarms have received a signal (takes about 7 seconds), their LED indicators will flash and the alarms will sound continuously. 6. Release the test button.
PAGE 4
The indicator on the remote The insulating film on the controller does not light up battery has not been peeled when I press the button. off. Peel off the insulating film. The battery is not properly Take out the battery and install it installed. again. Make sure the contacts are good. Smoke alarms do not respond The battery power is low. Replace with a new battery. Unsuccessful pairing. Pair the remote controller and to the remote controller. smoke alarms again.
PAGE 5
This device complies with part 15 of the FCC Rules. Operation is subject to the following tw o conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interf erence received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. Disposal This product must not be disposed of as household waste.