Operation Manual
X-POWER 2 IN 1 WIRELESS REMOTE OPERATION MANUAL
X-POWER 2 IN 1 wireless remote is one control system integrating wire control switch and remote control switch. The
control system is used to control power in and power out of X-POWER winches.
A. Press the START button of remote, then the remote can control the winch operation;
B. Plug in the Wire Control Switch to connect with control box, then you can control the winch operation through
Wire Control Switch.
◆ Remote range up to 66 ft.
◆ Visual signal indicator.
◆ Charging with USB C port, support fast charge.
◆ Flashlight up to 200Lumens.
◆ Vehicle battery voltage detection.
◆ OLI function for winch.
◆ Control function for fairlead LED light.
WARNING: This remote is special designed for X-POWER winch. The remote should not be used on hoist or winches
for industrial applications, include commercial car haulers/carriers, wrecker, crane, etc.
Technical Parameter:
1. Power: Vehicle power supply 12V for Receiver, Lithium battery 3.7V for Transmitter.
2. Transmission frequency: 2.4G two-way communication.
3. Ambient temperature: -20ºC ~ + 80ºC.
4. Waterproof: IP67.
5. Remote control distance: 66 feet.
6. Encoding: Learning code.
7. Adaptive voltage: 12V.
8. Transmitter: The transmitter turns off automatically without using it for five minutes.
9. Transmitter low power alarm: When the transmitter power is less than 30%, Yellow indicator light will flash.
Parts List:
Remote wireless transmitter: 1 PC.
Remote receiver: 1 PC.
USB data line: 1 PC.
Socket connection wire: 1 PC.
Installation and Connection
instruction:
The remote can be installed inside
control box. Please connect the
wire as below connection drawing
(Picture 1).
(Picture 1)