User Guide Dual Port Gigabit PCIe x1 Network Adapter Model No.: XM-NA3821 For the most up-to-date information, please visit www.x-mediausa.com Version 1.
Dual Port Gigabit PCIe Network Adapter Contents Package Contents ........................................................................................................... 3 Chapter 1 Product Overview …….………………….….……………………….………………………… 1.1 Introduction ……………………….…………………………………….………………….. 1.2 Features …….………………….….…..……………………………………………………… 1.3 LED Status …….…………………………..………………………..….……………………. 3 3 3 4 Chapter 2 Installation Guide ………………..…………………………………………..………………….. 4 2.1 Hardware Installation ………………………..
Dual Port Gigabit PCIe Network Adapter Package Contents The following items should be found in the package: Note: XM-NA3821 Dual Port Gigabit PCIe x1 Network Adapter Low profile bracket One CD Disk contains Drivers and User Guide The above list is for reference only. The actual content may differ according to the product you purchased. Please save the original packaging material for future reference. If any of the listed items are damaged or missing, please contact with your seller.
Dual Port Gigabit PCIe Network Adapter Support 10/100/1000Mbps NWAY Auto Negotiation Support Jumbo Frame to 9.5K bytes Support IPv 4, IPv 6 Protocols Support UDP.TCP and IP Checksum offloading Support Next Generation VMDq (8VMs) Wake-on-LAN and remote wake-up support Crossover Detection & Auto-Correction Support Standard and Low-Profile Chassis LED indicator for monitoring Link/Act 1.3 LED Status The Link/Act LED of Adapter indicates 10/100/1000Mbps status.
Dual Port Gigabit PCIe Network Adapter 3. Locate an available PCIe slot 4. Remove the screw that secures the slot bracket (the small piece of metal that covers the opening for PCIe card on the back panel of your computer), then remove the slot bracket 5. Carefully insert the Adapter into the PCIe slot. Please avoid touching the gold connector of the Adapter 6. Secure the Adapter to the case by using the screw you removed from the slot bracket 7. Reinstall your computer’s case cover 8.
Dual Port Gigabit PCIe Network Adapter you will see various options on the right side. Click Other Devices, and then from the drop-down list, please find Ethernet Controller. Right-click it and then select Update Driver Software. Figure 2.2 4. The Update Driver Software window will show up. Select Browse my computer for driver software. Figure 2.3 5. Browse and choose the system driver location from Computer, and then click Next.
Dual Port Gigabit PCIe Network Adapter Figure 2.4 6. Wait a few seconds for the installation. Figure 2.5 7. Click Close to finish the installation. Figure 2.
Dual Port Gigabit PCIe Network Adapter Appendix A: Specification Specifications: Standards: IEEE 802.3, 802.3u, 802.3ab, 802.3x, 802.1q, 802.1p Chipset: Intel JL82575EB Interface: 32-bit PCIe x1 Standard 2*10/100/1000Mbps RJ-45 port Data Transfer Rate: 10/100/1000Mbps for Half-Duplex mode 20/200/2000Mbps for Full-Duplex mode Network Media: 10Base-T: UTP Cat. 3, 4, 5, cable (Maximum 100m) EIA/TIA-568 100Ω STP (Maximum 100m) 100Base-TX: UTP Cat.