User's Manual

Winterm

™

Model 9650XE XPE-Based Terminal

Quick-Start Guide

➊

Connect –

Caution: Improper connection, mounting, or use of this product could result in component failure and/or flash

memory corruption. Read the following caution statements before setting up and operating the terminal.

(FIGURE TO BE SUPPLIED)

Caution Statements:

Setup

• Do not connect power until all other connections are made. Connecting or disconnecting components

or devices on the back panel when the terminal is receiving power can cause power surges and damage the

terminal. (USB ports are hot-swappable.)

• Do not force a connector into its socket. If any undue resistance is encountered, ensure that the connector is

correctly oriented to the receptacle.

Orientation and Venting

• Mount the terminal only as shown above or in accordance with the instructions provided with the Wyse-

approved wall mount (see Note that follows). Improper orientation (such as component side down, where the

back panel’s symbols are upside down) could inhibit the dissipation of heat from the terminal and damage it.

• Allow sufficient space around the terminal for ventilation; do not place the terminal in any enclosure that

restricts airflow around the terminal; do not place any objects on the terminal. Product environmental

specifications are available through Wyse’s Web site at http://www.wyse.com/products/winterm/products.htm

1 PS/2-type mouse interface 6 Video port 11 +12V Power cable interface

2 Parallel port 7 USB port (2) 12 Floppy drive (optional)

3 Network connection, 10/100Base-T 8 Speaker out 13 USB port (2)**

4 Serial port 9 Line in 14 CD-ROM drive (optional)

5 PS/2-type keyboard interface 10 Microphone

*Supplied for U.S.A.; in other locales, check package contents or contact your Wyse reseller.

**Front USB ports not available if floppy drive option is installed.

PAGE 1
Winterm™ Model 9650XE XPE-Based Terminal Quick-Start Guide ➊ Connect – Caution: Improper connection, mounting, or use of this product could result in component failure and/or flash memory corruption. Read the following caution statements before setting up and operating the terminal.
PAGE 2
Power Sources • To ensure regulatory compliance, use only the power supply included in the shipping box, or a Wyse-approved equivalent, with the terminal. Also, the noise suppressor (ferrite bead) included in the box with the terminal must be installed on the network cable as described following these caution statements. Refer to the regulatory notices in the terminal’s on-line documentation at http://www.wyse.com/products/ winterm/quickstart/9000.htm.