xi FCC Statement This equipment has been tested and found to comply with the limits for either Class Aor Class B digital devices {refer to “Terminal Requirements Compliance”), pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
Class B ‘This digital apparatus does nat exceed the Class B limits for radio noise emissions from digital apparatus set out in the Radio Interference Regulations of the Canadian Department of Communications. Le present apparel numeric nonmetal pas de bruits radiotelephones depressant les limited applicable aux apparels communiques de la class B prescribes sand le Regalement sur le bouillabaisse hydroelectric dict par le Minister des Communications du Canada.
Noise Suppressor Installation A noise suppressor (fer rite bead) must be installed on the network cable of your terminal. This installation is necessary to maintain compliance with US FCC B limits and European CRISP B EN55022 Class B limits. The noise suppressor is supplied by the manufacturer and is packed in your terminal's shipping carton. Figure 55-1 shows the noise suppressor, Figure §5-1 Noise Suppressor To install; 1. Open the casing. 2.