User's Manual

TM
INSTRUCTIONINSTRUCTION
Battery Installation and Power On/Off
Flametop
Flathead
Whiplash
0250 Asst.
AGES 4+
Battery Requirements
Monster Rod 6 x AA
Controller 1 x 9V
Batteries Not Included
WARNING: Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user’s authority to operate the equipment.
Please keep these instructions as they contain important information
WARNING: Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user’s authority to operate the equipment.
Please keep these instructions as they contain important information
Safety Precautions
• Never drive your Monster Rod on the streets.
• Do not pick up the vehicle while it is in motion.
• Keep fingers, hair and loose clothing away from the tires and wheels while the vehicle is in motion.
• Do not drive the vehicle through water.
• For best results, hold the antenna up, not pointing down towards the vehicle.
• Drive safely!
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) This device must accept any interference received, including interference that may cause
undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is needed.
• Consult the dealer or an experienced radio/TV technician for help.
Monster RodsMonster Rods
ControllerController
Power Indicator Light
Steering Wheel
Throttle Forward
Throttle Reverse
Push Throttle Forward to make the Monster Rod roar forwards.
Forward
Rotate the steering wheel to the right to make the Monster Rod
spin to the right.
Right Spin
While driving forwards or backwards, briefly rotate the steering
wheel to the right to make the Monster Rod turn to the right.
Right Turn
Push Throttle Reverse to make the Monster Rod scream
backwards.
Reverse
Rotate the steering wheel to the left to make the Monster Rod
spin to the left.
Left Spin
While driving forwards or backwards, briefly rotate the steering
wheel to the left to make the Monster Rod turn to the left.
Left Turn
Wheelie & Mouth Open
Driving the MONSTER RODS
• Turn on the Monster Rod and the controller using the On/Off switches as shown in the Battery Installation and Power On/Off section of this
instruction sheet.
• The power indicator light on the controller will glow as long as the battery has power.
Driving Tips:
If you hold the wheel in a turn while driving forward or backwards the Monster Rod will spin
out. Practice doing this for quick direction changes.
Remember that when the vehicle is coming towards you, it will steer in the opposite
direction to the way you turn the wheel. Try to imagine that you are in the driver’s seat to
work out the direction it will turn in.
To perform a wheelie, drive in reverse and quickly push the throttle forward. The driver will
open his mouth and let out a monstrous laugh as the front wheels lift off the ground.
When you have finished playing, make sure that you turn the On/Off switch on the controller
and Monster Rod to “Off”.
or or
OFF ON
9V
6LR61
1) Remove the battery compartment cover using a Phillips or crosshead  
 screwdriver (not included).
2) Insert 1 x 9V battery (not included) as shown in the diagram.
3) Replace the battery compartment cover and the screw.
1) Remove the battery compartment cover using a Phillips or crosshead  
 screwdriver (not included).
2) Insert 1 x 9V battery (not included) as shown in the diagram.
3) Replace the battery compartment cover and the screw.
On/Off Switch
Battery Compartment Cover
Manufactured and distributed by
© 2004 WowWee Ltd.
All Rights Reserved.
WowWee (Asia Office)
Unit 301A-C, 92 Granville Rd.,
T.S.T. East, Hong Kong
WowWee (North America Office)
4480 Cote de Liesse, Suite 320,
T.M.R. Quebec, H4N 2R1, Canada
Consumer Hotline: [phone]
www.wowwee.com
We recommend that you retain our
address for future reference.
Printed in China.
NG0250US01
Manufactured and distributed by
© 2004 WowWee Ltd.
All Rights Reserved.
WowWee (Asia Office)
Unit 301A-C, 92 Granville Rd.,
T.S.T. East, Hong Kong
WowWee (North America Office)
4480 Cote de Liesse, Suite 320,
T.M.R. Quebec, H4N 2R1, Canada
Consumer Hotline: [phone]
www.wowwee.com
We recommend that you retain our
address for future reference.
Printed in China.
NG0250US01
"
AA
"
/ LR
06/ UM3
1.5
V
"
AA
"
/ LR
06/ UM3
1.5
V
"
AA
"
/ LR
06/ UM3
1.5
V
"
AA
"
/ LR
06/ UM3
1.5
V
"
AA
"
/ LR
06/ UM3
1.5
V
"
AA
"
/ LR
06/ UM3
1.5
V
ONOFF ONOFF
1) Remove the battery compartment cover using a Phillips or crosshead 
 screwdriver (not included).
2) Lift out the battery compartment using the handle.
3) Insert 6 x AA batteries (not included) as shown in the diagram.
4) Replace the battery compartment, making sure that the metal 
 contacts on the compartment are 
 in the correct position to engage 
 with the metal contacts in  
 the car.
5) Replace the battery 
 compartment 
 cover and the 
 screw.
1) Remove the battery compartment cover using a Phillips or crosshead 
 screwdriver (not included).
2) Lift out the battery compartment using the handle.
3) Insert 6 x AA batteries (not included) as shown in the diagram.
4) Replace the battery compartment, making sure that the metal 
 contacts on the compartment are 
 in the correct position to engage 
 with the metal contacts in  
 the car.
5) Replace the battery 
 compartment 
 cover and the 
 screw.
Battery
Compartment
Cover
Removable
Battery
Compartment
Bottom of Monster Rod Back of Controller
Attention: Important Battery Information
•  Use only fresh batteries of the required size and recommended type.
•  Do not mix old and new batteries, different types of batteries (standard alkaline, or 
 rechargeable), or rechargeable batteries of different capacities. We recommend the 
 use of rechargeable batteries.
•  Remove rechargeable batteries from the toy before recharging them.
•  Rechargeable batteries are only to be charged under adult supervision.
•  Please respect the correct polarity, (+) and (-).
•  Do not dismantle batteries of any type.
•  Do not try to charge non-rechargeable batteries.
•  Do not throw batteries into the fire.
•  Replace all batteries of the same type/brand at the same time.
•  Do not short-circuit the battery contacts.
•  Remove exhausted batteries from the toy.
•  Batteries should be replaced by adults because of small parts.
•  Remove batteries if the toy is not going to be played with for some time.