Instructions / Assembly
1
INSTRUCTION MANUAL
CHANDELIER FIXTURE
IMPORTANT SAFETY INSTRUCTIONS
INSTALLATION INSTRUCTIONS PERTAINING TO RISK OF FIRE OR INJURY TO PERSONS
1. Read all instructions.
2. Do not install this lighting system in wet locations.
3. CAUTION - When the light is on, the lamp is HOT!
4. CAUTION - Hot surface. Keep away from curtains and other combustible materials.
5. Turn off/unplug and allow to cool before replacing bulb (lamp).
6. All electrical connections must be in accordance with local codes and the National Electrical Code. If
you are unfamiliar with methods of installing electrical wiring, secure the services of a qualified
licensed electrician.
7. This fixture is intended to be mounted to a 4in. square x 2-1/8in. deep metal octagon outlet box. The
box must be directly supported by the building structure.
8. Before starting the installation, disconnect the power by turning off the circuit breaker or by removing
the appropriate fuse at the fuse box. Turning the power off using the light switch is not sufficient to
prevent electrical shock.
SAVE THESE INSTRUCTIONS
TOOLS NEEDED (not included): Ladder, Safety goggles, Gloves, Flathead screwdriver, Phillips screwdriver, Electrical
tape, Wire strippers, Bulb.
FIXTURE BODY ASSEMBLY INSTRUCTIONS
Refer to the Diagram for reference of the parts
1. Carefully unpack the fixture and lay all of the parts out on a clean surface.
2. Threaded the straight tube A, straight tube B and fixture loop into the fixture body and tighten it in
place.
3. Attach the bent tube on to the fixture loop and tighten with the decorative pillar A, then place the upper
decorative plate on to the otherside of bent tube and tighten with the manual nut.
4. Secure the glass shade on to the socket of fixture body, place the canble cover on to the socket and
screw the bulb (not included) onto the lamp-socket.
CAUTION: Refer to the re-lamping label located on the fixture. Do not exceed recommended wattage.
5. Secure the threaded tube onto the hex coupler of fixture body, then place the fixture cup and tighten
with the fixture ring.
6. Through the decorative stem to the bent tube on the upper decorative plate and tighten with the
decorative pillar B, place the bottom decorative plate on the otherside of the decorative stem and
tighten with the decorative pillar B.
CEILING ASSEMBLY INSTRUCTIONS
1. Make sure the electrical power is off and pull leads down out of junction box.
2. Adjust the length of the chain according to the desired height by removing unnecessary links.
3. Thread the fixture wire and the ground (bare) wire through the chain, feeding it through alternating
links, then through the canopy loop. Loosen the loop ring on the canopy loop and allow ring to slide
down over the chain.
4. Slide the canopy over the canopy loop and the chain (leave ring and canopy loose on chain at this time).
5. Insert and secure the threaded nipple into the canopy loop.
6. Attach the mounting strap to the outlet box using the two outlet box screws provided.
7. Raise the assembled fixture to allow for installation to junction box. Feed the wire and ground wire
through the hole in the center of the mounting strap and rotate the threaded nipple, canopy loop and
preassembled fixture clockwise until the threaded nipple is secure in the mounting strap. Make sure the
fixture cable and ground wires are not twisted during this process.
8. Wrap the ground wire under and around the ground screw which is marked “GND”, and fasten the
ground screw to make sure the ground wire is securely connected.
9. Make the ELECTRICAL CONNECTIONS (Required Supply Circuit: 120V, 60Hz):
a. Connect the neutral wire (with raised ribs and without writing) from the fixture to the neutral (white)
ES7763PR
ES7764PR