MODEL WSP-R240 (2inch Mobile Printer) Rev. 2.0 WOOSIM SYSTEMS Inc. #501, Daerung Technotown 3th, 448, Gasan-Dong, GeumChun-Ku, Seoul, Korea Tel : +82-2-2107-3700 Fax : +82-2-2107-3707 URL: http://www.woosim.com All specifications are subjected to change without notice http://www.woosim.
WSP-R240 Rev. 2.0 Copyright WSP-R240 2inch mobile printer operator’s manual. Copyright ⓒ2011 by Woosim Systems Inc. All rights reserved. The information contained in this manual is the property of Woosim Systems Inc. And may not be reproduced in whole or in part without the prior written permission of Woosim Systems Inc. Trademark a registered trademark of Woosim Systems Inc. All other trademark are the properties of their respective companies.
WSP-R240 Rev. 2.0 Introduction The WSP-R240 is suitable designed for use with a growing variety of mobile devices. Bluetooth/Serial interfaces make the WSP-R240 the perfect comrade for applications such as point of transaction warehousing, distribution, point of sales, hospitality, gaming and healthcare. The general features of WSP-R240 printer are as follows: Pocket size (79.5 X 114.3 X 43.6mm) Light weight (217g) for true mobility. Very silent printing thru direct thermal printing method.
WSP-R240 Rev. 2.0 Operating Precautions Please follow the precautions below to enjoy and maintain the full performance of the printer. Using the Printer ● Be careful not to drop or bump the printer on a hard surface. ● Do not install the printer in direct sunlight or such areas.
WSP-R240 Rev. 2.0 Note FCC ID : QDDWSP-R240 This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
WSP-R240 Rev. 2.0 CONTENTS 1. Outline ..........................................................................................................................................7 1.1. Model classifications..........................................................................................................7 1.2. Product Part Number System...........................................................................................7 1.3. Specifications........................................................
WSP-R240 Rev. 2.0 1. Outline 1.1. Model classif ications WSP-R240 ( ) ( ) Model Interface A1:UART/Bluetooth Power None : DC 8.4V 1.2. Product Par t Number System Model name SC30 W25 . . . 2. Porti-SC30 Note) Interface Spec. Wired S40 Example) 1. Porti-S40 / Wireless A RS-232C 1 Bluetooth B TTL 2 IrDA C USB 0 None D RS-485 E Parallel Z None UART/Bluetooth Part No. ⇒ S40/A1 Bluetooth Only Part No. ⇒ SC30/Z1 The above table is the interface format which is supported.
WSP-R240 Rev. 2.0 1.3. Specif ications. Item Specification Printing method Direct thermal line printing Characters per line 42cpl (MAX) Character size Eng. : 9*24dots, 12*24dots Optional Characters Simplified/Traditional Chinese, Arabic, Cyrillic, Russian, Turkish, Greek, Japanese, Persian, Latin9 and Others upon request. Resolution 203dpi, 8dots/mm Print width 2-inch (48mm, 384dots) Printing speed 80mm / sec (MAX) Dimensions Weight Interface Kor. : 16*24dots, [24*24dots] 79.5 X 114.
WSP-R240 Rev. 2.0 Item Environment Conditions MCBF (Mean Cycle Between failure) Specification Temperature -10°C ~ 70°C (storage) 30% - 80% (operating) Humidity 10% - 90% (storage) Mechanical Head -10°C ~ 50°C (operating) 37,000,000 lines Approximately 50 Km < Table 1 > http://www.woosim.
WSP-R240 Rev. 2.0 2. Setting up the printer 2.1. Printer & Accessories Your printer box should include these items. If any items are damaged or missing, please contact your dealer for assistance. Thermal roll paper Battery Pack WSP-R240 Battery charger adaptor Communication cable ▼ OPTIONAL External Battery Cradle MSR http://www.woosim.
WSP-R240 Rev. 2.0 2.2. Printer Features ▶ Part Name http://www.woosim.
WSP-R240 Rev. 2.0 ▶ Dimensions http://www.woosim.
WSP-R240 Rev. 2.0 2.3. Replacing the paper roll Note : Be sure to use paper rolls that meet the specifications. Do not use paper rolls that have the paper glued to the core because the printer can not detect the paper end correctly. 1. Make sure that the printer is not receiving data; otherwise, data may be lost. 2. Open the paper cover as the “One-Touch” way by pressing the button in the arrow direction like the picture. 3. Insert the paper roll as shown. 4.
WSP-R240 Rev. 2.0 2.4. Power supply 2.4.1. Internal power supply The following specification is requested for Power supply. Battery Charger : DC 8.4V/0.8A Avoid using power supply which its power capacity of power current is extremely high. 2.4.2. Installing the Batter y NOTE : ● Before installing or removing the battery pack, ensure the printer is OFF. ● If the printer is not used for long period of time, remove the battery pack from the printer.
WSP-R240 Rev. 2.0 2.4.3. Recharging the batter y For recharging the battery pack, install the battery pack in the printer. Insert the Battery Charger or External Battery Cradle to the charge connector of the printer. NOTE : ● While charging the printer, turn off the printer power. ● Do not remove the battery during charging. ● The battery is consumable parts and when purchasing, compared to the use hour is gradually decreases.
WSP-R240 Rev. 2.0 2.5. Set operation mode In keeping on pressing the Feed and Power button simultaneously until after the ERROR lamp blinks 5 times, the printer comes out at the circumstance to change the printer mode. (refer Table 2) POWER button : use for changing OPTION status. (Error Lamp) FEED button : use for changing MODE status.
WSP-R240 Rev. 2.0 When you press FEED Button once again, Power Lamp flickers 5 times and Error Lamp flickers once. Press POWER Button once, Error Lamp flickers twice. And then the density has set to 2 stop bit. When you press FEED Button once again, Power Lamp flickers 6 times and Error Lamp flickers once. Press POWER Button twice, Error Lamp flickers 3 times. And then the density has set to Density high.
WSP-R240 Rev. 2.
WSP-R240 Rev. 2.0 MODE Power Down POWER Lamp ERROR Lamp (Green) (Red) 9 Option 1 No use 2 1 minute 3 2 minute 4 3 minute 5 4 minute 6 5 minute < Table 2 > http://www.woosim.
WSP-R240 Rev. 2.0 3. Interface 3.1. UART(RS-232C or TTL) or USB (Fig.3.1) The WSP-R240 printer has a UART(RS-232C or TTL) or USB interface and is connected by means of a 5 pin mini USB socket. In the following table, the signals present on the Mini- USB socket are listed: ① UART(RS-232C) ② USB Pin no Signal Name Direction Function Pin no Signal Name 1 TxD Output Transmit Data 1 VCC 2 RxD Input Receive Data 2 DATA “+” 3 CTS - - 3 DATA “-” 4 NC.
WSP-R240 Rev. 2.0 3.2. Bluetooth Category Specification Bluetooth Spec. Bluetooth Ver2.1 +EDR / Class2 (10m) Frequency Range 2.4GHz ISM BAND (2 402 ~ 2 480 MHz) RF POWER Below 10 dBm Modulation method GFSK, PSK Data Transmission Rate 57600bps Fixed. Data bit 8 Data bit Fixed. Parity bit No parity Fixed. Stop bit 1 Stop bit Fixed. 3.3. Card Reading Please take notice that Magnetic Stripe Card should be swapped in direction of arrow. Card can be read in both http://www.woosim.
WSP-R240 Rev. 2.0 4. Using the printer 4.1. Control panel (Fig.4.1) Button - FEED Button: When the printer is on, paper can be feed manually by pressing and holding the FEED button for more than one second. - POWER Button: ① When of 5 or more seconds presses and power comes to on or off. ② After pressing the POWER and the FEED button simultaneously, if the ERROR lamp 5 turn signals POWER button is converted with MODE functions.
WSP-R240 Rev. 2.0 Panel lamp - Power : Printer is ON and ready to receive data. (GREEN) - Error (RED) : Indicates a fault condition or a printer error. (i.e : no paper, paper cover opened. etc.) - Bluetooth : Indicates a Bluetooth connection status. (BLUE) - Battery Power : These lamps(Green) indicated the battery power remaining. (GREEN) The battery gain in quantity and these lamps are on the decrease. If so, you must recharge the battery by using the battery charger. 4.2.
WSP-R240 Rev. 2.0 5. Consumable Parts 5.1. Recommended paper Type : Thermal Paper Paper width : 58mm Paper thickness : 60±5㎛ Outer diameter : Ø40mm or less Recording side : Outside of roll Cautions 1. Do not paste the paper to the core, and the roll paper which has near end mark printing on its near end is recommended. 2. Chemicals or oil may change the color of paper, or printed characters may fade. 3. Change of paper color starts from approx. 70 ℃.
WSP-R240 Rev. 2.0 6. Revision Histor y Date Version Comments Mar. 03. 2011 1.0 Initialize May. 03. 2011 2.0 Weight Change http://www.woosim.