Installation Instructions
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference,
and (2) this device must accept any interference
received, including interference that may
cause undesired operation.
FCC CERTIFIED
#P[EJCPIGUQTOQFKſECVKQPUPQVGZRTGUUN[CRRTQXGFD[
the party responsible for compliance could void the user's
authority to operate the equipment. NOTE: This equipment
has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the
FCC Rules.
These limits are designed to provide reasonable protection
against harmful interference in a residential installation.
This equipment generates,uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful interference to
radio or television reception, which can be determined
by turning the equipment off and on, the user is
encouraged to try to correct the interference by
one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment
and receiver.
- Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
%QPUWNVVJGFGCNGTQTCPGZRGTKGPEGF technician
6QOCKPVCKPEQORNKCPEGYKVJ(%%ŏU4('ZRQUWTG
guidelines, This equipment should be installed
and operated with minimum distance between
20cm the radiator your body: Use only the
supplied antenna.
FCC INFORMATION