Installation Instructions

FCC Warning:
This device complies with part 15 of the FCC Rules. Operation is subject to
the
following two conditions: (1) this device may not cause harmful interference
, and (2)
this device must accept any interference received, including interference
that may
cause undesired operation.
Any changes or modifications not expressly approved by the party responsible
for
compliance
could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for
a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and
, if not installed and used in accordance with the instructions, may cause
harmful
interference to radio communications. However, there is no guarantee that
interference
will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception,
which can be determined by turning the equipment off and on, the user is
encouraged to
try to correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help. The
device has
been evaluated to meet general RF exposure statement.
The device can be used in portable exposure condition without restriction
Warning: Changes or modifications to this unit not expressly approved by the
part
responsible for compliance could void the user’s authority to operate the
equipment