Quick Start Guide
Power on
1. Open the charging case
2. Press and hold the function button for 3
seconds,the earbuds are now ready for pairing
1
Bluetooth Pairing
Turn on Bluetooth on your phone,select
“WS001” and follow up the introduction to
complete pairing.
2
WS001
Tap controls
Under the condition of wearing both ears
Answer calls/hang up , double top the right earbud
during calls, removing both earbuds, audio can be
switched to the device. Reinsert them, audio can
be switched to the earbuds.
Play /stop music , double top the right earbud.
Removing either one of your earbuds will pause
the audio Reinsert it to resume playback.
3 4
Quick start guide
Tap Area
Noise Cancellation
Under the condition of wearing both ears
Turn on/off noise cancellation;
Double tap the left earbud.
Remark:
1.ANC Off in normal
2. Noise cancellation mode cannot be turned
on when only wearing one ear
3. Removing either one of your earbuds will turn
off ANC. Re insert it back to resume ANC
Tap Area
5
Charging your eaebuds
Place your earbuds into the charging case to
start charging them.
6
Charging the charging case FCC WARNING:
Wired charging : Use the USB-C charging cable
included to charge the charging case.
When charging ,the indicator shows rerd , and
green indicates full.
Wireless Headphones
WS001
Note: This equipment has been tested and found
to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment generates
uses and can radiate radio frequency energy and,
if not installed and used in accordance with the
instructions, may cause harmful interference to
radio communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television
reception, which can be determined by turning the
equipment off and on, the user is encouraged to
try to correct the interference by one or more of the
following measures:
-Consult the dealer or an experienced radio/TV
technician for help.
The device has been evaluated to meet general RF
exposure requirement. The device can be used in
portable exposure condition without restriction.
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference,
and
(2) this device must accept any interference
received, including interference that may cause
undesired operation.
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment
and receiver.
-Connect the equipment into an outlet on a circuit
different from that to which the receiver is
connected.