*** USER’S MANUAL *** FCC ID : SRKWPSPT100
FCC label requirement Please note : (1) The device must be designed for mobile or fixed operation only. (portable is not permitted and requires separate approval) (2) The device bear a label with FCC ID:SRKWPSPT100 attached on the bottom of the device and a second label with FCC ID:UDV-0606020060002 attached on RF module inside the device .
FCC RF exposure requirement To allow compliance with RF exposure requirement for the device which maximum output power at antenna input terminal: (a) For GSM 850MHz / GSM 900MHz band is 33dBm (= 2W ) , the maximum antenna gain with cable is 0.5 dBi . (b) For DCS1800MHz / PCS1900MHz band is 30dBm (= 1W) ,the maximum antenna gain with cable is 1.0 dBi .
System Modes 1. Normal Mode : A. Normal : Power Button Long Press : Power OFF. Power Button Short Press : Switch To GPS Info. Mode. Button 1 Long Press : Parking ON/OFF Button 2 Long Press : Dial Emergency Phone 1 (Set Up By Utility). Button 3 Long Press : Dial Emergency Phone 2 (Set Up By Utility). Button 4 Long Press : Dial Emergency Phone 3 (Set Up By Utility). Button 5 Long Press : Send Emergency SMS (Set Up By Utility).
B. When Ring In : Power Button Long Press : Power OFF. Power Button Short Press : Pick Up Phone. Button 1~4 Short/Long Press: Pick Up Phone. Button 5 Short/Long Press: Hand Up Phone.
C. When Talking : Power Button Long Press : Power OFF. Button 3 Short Press: Volume Up. Button 4 Short Press: Volume Down. Button 5 Short Press: Hand Up Phone.
C. When Parking Enable: Power Button Long Press : Power OFF. Button 3 Short Press: Volume Up. Button 4 Short Press: Volume Down. Button 5 Short Press: Hand Up Phone.
2. GPS Information Mode : No Fix : Fix : A. Normal Power Button Long Press : Power OFF. Power Button Short Press : Switch To Dial Phone Mode. Button 2 Long Press : Dial Emergency Phone 1 (Set Up By Utility). Button 3 Long Press : Dial Emergency Phone 2 (Set Up By Utility). Button 4 Long Press : Dial Emergency Phone 3 (Set Up By Utility). B. When Ring In : Power Button Long Press : Power OFF. Power Button Short Press : Pick Up Phone. Button 1~4 Short/Long Press: Pick Up Phone.
Power Button Long Press : Power OFF. Power Button Short Press : Switch To Normal Mode. Button 1 Short Press : Select Current Number To Dial List. Button 2 Short Press : Clear Current Number To Dial List. Button 3 Short Press : Right Shift Number . Button 4 Short Press : Lift Shift Number . Button 5 Long Press : Dial Out.
Utility Setting 1. Unit Setting Unit ID : The identification number of the unit. The default unit ID is 1010000001. Pin Code : The PIN code of the GSM/GPRS SIM card. (Max. 4 digits) Sync. Timer : Synchronization message sending interval in seconds.(10 ~ 65535 seconds) 0: Only one sync message be transmited when the unit connected to the server. GPRS APN : GPRS Access Point Name. (Max. 35 characters) GPRS User Name : GPRS login user name (Max. 15 characters) GPRS Password : GPRS login password (Max.
1-1.
2.
2-1.
3.
3-1. Select Firmware file (*.
3-2.
3-3.