*** USER’S MANUAL *** FCC ID : SRKWPBT100NX
The Federal Communication Commission Statement This equipment has been tested and found to comply with the limits for a Class B Digital Device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instruction, may cause harmful interference to radio communication.
GPS Bluetooth Receiver User’s Guide Bluetooth GPS Receiver User’s Guide
Bluetooth GPS Receiver User’s Guide Table of Contents 1. 2. 3. 4. 5. 6. Read Me First………………………………………………………………………………….. p.3 Box Contents…………………………………………………………………………………… p.3 Getting Started…………………………………………………………………………………. p.3 Hardware Description…………………………………………………………………………. p.7 LED Indicator…………………………………………………………………………………... p.8 Specification……………………………………………………………………………………. p.
Bluetooth GPS Receiver User’s Guide 1. Read Me First 1. The battery must be charged for at least 8 hours for the ‘INITIAL’ use. The LED1 (ORANGE) will turn off after 3 hours’ charging, please keep on charging for 5 more hours. Thereafter, for each time’s battery charging please fully charge for 3 hours. 2. We strongly recommend that remove the battery if the device will not be used for over 2 weeks. Do not remove the battery within 2 weeks. 3.
Bluetooth GPS Receiver User’s Guide BTGPS Click here Click here to select installation 4
Bluetooth GPS Receiver User’s Guide BTGPS **** Enter Pass Key "0000", then Press “Enter” Enter key BTGPS BTGPS Click here Click here 5
Bluetooth GPS Receiver User’s Guide Connection established BTGPS: SPP slave The connection between GPS Bluetooth receiver and PDA has been successfully established 5. Turn off the GPS Bluetooth receiver Press the power button for 1 second, all LEDs will goes off. We recommend that close the E-map before turning off the GPS Bluetooth receiver, in order to avoid any possible PDA /PC freeze.
Bluetooth GPS Receiver User’s Guide 4.
Bluetooth GPS Receiver User’s Guide 5. LED Indicator Power on: LED1: Charging Status LED2: GPS Fix Status N/A LED3: Power Status LED4: Bluetooth Status N/A Blue Blinking quickly for the first 5 sec.
Bluetooth GPS Receiver User’s Guide 6. Specification GPS Features Datum Chipset SiRF Star III WGS-84 Frequency L1, 1575.42MHz Dynamic Conditions C/A Code 1.023MHz chip rate Altitude <18,000 m (60,000feet) Channels Supports 20 channels Velocity <515 m/s (1000 knots) Antenna (Internal) Built-in low noise antenna Acceleration <4G Motional Jerk 20m/sec3 max.
