User's Manual

ManualsBrandsWombat ManualsElectronicsGinkgo

WM69 User Manual Version 1.0 Page 1

 Factory Default Setting:

• Keyboard is in macOS mode

• Batteries are NOT installed

• 2.4GHz RF Receiver is paired with the keyboard

 Toggle between macOS mode and Windows mode

You must be in macOS Mode to use Mac hot keys. You must be in Windows

Mode to use Windows hot keys.

Enter macOS mode LEDs status Enter Windows mode LEDs status

Hold Fn + A

for 3 secs

LED blinking

Hold Fn + M

for 3 secs

LED blinking

Anytime when holding the Fn key alone:

• LED at ESC is ON means the keyboard now is in MAC mode

• LED at ESC is OFF means it is in Windows mode.

• LED at Caplock will be ON if the Caplock mode is ON. Otherwise, the LED will be

OFF.

 Battery

• Please install two AAA size batteries into the battery compartment

for wireless connection.

• When Capslock LED blinks along with any key presses, this means the

Battery power is low and charging is required.

• When the keyboard is connected to a USB host, the keyboard is

automatically switched to USB mode.

• To conserve battery power, all LEDs are deactivated in wireless

mode. Hold the Fn key to see all the current status of LEDs.

Summary of content (5 pages)

PAGE 1
 Factory Default Setting: • • • Keyboard is in macOS mode Batteries are NOT installed 2.4GHz RF Receiver is paired with the keyboard  Toggle between macOS mode and Windows mode You must be in macOS Mode to use Mac hot keys. You must be in Windows Mode to use Windows hot keys.
PAGE 2
 Wireless connection RF and Bluetooth pairing Switch between Wired and Wireless mode WM69 User Manual Version 1.
PAGE 3
 Encoder Clockwise = Vol + Fn + Clockwise = LCD Brightness up (Only for Laptop) Anti-Clockwise = Vol Fn + Anti-Clockwise =  Macro Editing Mode 1. Press Fn + Backspace to enter Macro Editing Mode, the LED at Esc key will blink. 2. Select any of the keys [ Q/W/E/R/T/Y/U/I/0/P ] to be programmed as the macro hot key. 3. You can press Fn + [ or ] to add a delay between each character. 4. After editing the macro, press Fn + Enter to save the macro. 5. Repeat steps 2 to 4 to program more macros 5.
PAGE 4
 Shortcut keys * Requires setup in System Preferences ** Press Fn + Shift + Esc will come out the key “~” WM69 User Manual Version 1.
PAGE 5
 FCC warning This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.