Quick Setup Guide DCX-500i / DCX-1000i / DCX-1500i Projectors with WC-Pro Scaler Preliminary
Table of Contents Introduction............................................................................................................ 1 Connecting the Projector....................................................................................... 1 Installing the Primary Lens.................................................................................... 2 Connecting the Scaler...........................................................................................
Introduction Wolf Cinema’s DCX line of projectors are designed to work in conjunction with the WC-Pro Scaler. The Scaler is calibrated at the factory and is to be used to route the variety of inputs it supports; 6 HDMI, 1 Component, 1 Component/RGB, 1 S-Video and 1 Composite Video. Each projector is ships with 10 preset Channel Memories, which are programmed at the factory.
Installing the Primary Lens Before installing any lens, be sure the projector is off. If the projector has been running, be sure to let it cool down completely. Ensure the front lens cap is on during installation. NOTE: Remove the small rear lens cap before installing!! Keep the large front cap on. 1. Electrical Connector: Line up the male connector on the lens with the female connector on the slide assembly.
Connecting the Scaler 1. Connect all sources to the inputs of the scaler. 2. Connect a HDMI cable from the video output on the scaler to input 2(DVI) in the projector. 3. Connect power to the AC input using the provided power cable. The scaler will automatically turn on. If a Red LED is shown on the right side of the front panel, the Scaler is receiving AC power but no signal is detected. If a Blue LED is shown, the Scaler is receiving AC power and a good video signal is being detected.
The GPIO and VariScope 2.35 Memory Structure The Projector has 99 channel memory locations. Channel Memory 1-5 are to be used without the Anamorphic VariScope 2.35. Channels Memory 6-10 are to be used with the Anamorphic VariScope 2.35. Every block of 10 Channel Memory inputs will be structured in the same manor. (1-5 no anamorphic lens, 6-10 anamorphic lens.) Adjusting the VariScope Lens System The VariScope lens system is enabled at the factory with in the projectors menu .
Changing the Numerical Location of Channel Memories GPIO Channel Memory Structure As a channel is being copied, the channel memory should be assigned to its proper location. button on the remote. The projectors 1. Select the channel memory by pressing the Menu OSD will appear. 2. Scroll with the Up pressing the Enter 3. The channel list from the OSD will appear. 4. Highlight the desired channel and select the Enter will appear. 5.
Wolf Cinema Quick Setup Guide Channel GPIO Control to VariScope 2.35 Input/GPIO Selection at Scaler Channel GPIO Control to VariScope 2.
Wolf Cinema . 2431 Fifth Street . Berkeley . CA 94710 . Ph: 510.843.4500 . Fax: 510.843.7120 . www.wolfcinema.