User Instructions

Table Of Contents

IoT Module instructions

1. Connect 4p shielded cable to IoT module COM port. And

connect the end of shielded cable to host device COM port.

(Make sure host device COM port VCC is rated for 3.3V). IoT

module will be powered by host device COM port.

2. Connect an extension button cable to AP port if required to

extends AP button location.

3. Connect an extension LED cable to LED port if required to

extends LED location.

4. Connect 4p cable to ACC port if required to communicate

with 3

device.

5. Reset button can be pressed to reboot IoT module.

Wolf Steel LTD.

PAGE 1
IoT Module instructions 1. Connect 4p shielded cable to IoT module COM port. And connect the end of shielded cable to host device COM port. (Make sure host device COM port VCC is rated for 3.3V). IoT module will be powered by host device COM port. 2. Connect an extension button cable to AP port if required to extends AP button location. 3. Connect an extension LED cable to LED port if required to extends LED location. 4. Connect 4p cable to ACC port if required to communicate with 3rd device. 5.
PAGE 2
FCC Caution This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
PAGE 3
IC Caution: - English: This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) This device may not cause interference, and (2) This device must accept any interference, including interference that may cause undesired operation of the device. - French: Le présentappareilestconf orme aux CNR d' Industrie Canada applicables aux appareils radio exempts de licence.