User’s manual IEEE 802.11 b/g/n Wi-Fi Module Version 0.1 Edition # Reason for revision Issue date Editor Reviewer Approver V0.1 Generic Version 2017/07/13 Ben Chang Alex Chang Alex Chang V0.
1. 2. 3. 4. 5. 6. 7. FCC Statement .......................................................................................................................................3 Introduction............................................................................................................................................5 2.1 Scope................................................................................................................................................5 2.2 Applicable Documents ....
1. FCC Statement Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
Integration instructions for host product manufacturers Applicable FCC rules to module FCC Part 15.247 Summarize the specific operational use conditions The module is must be installed in mobile device.
“Contains FCC ID: NKR-A3” with finished product Information on Test Modes and Additional Testing Requirements Test tool: QATool V 0.0.0.96 shall be used to set the module to transmit continuously. Additional Testing, Part 15 Subpart B Disclaimer The module is only FCC authorized for the specific rule parts listed on the grant, and that the host product manufacturer is responsible for compliance to any other FCC rules that apply to the host not covered by the modular transmitter grant of certification.
2.3 Product Photograph (SGB) 3. Key Features Wi-Fi Key Feature IEEE 802.11b/g/n compliant Support 20, 40MHz in 2GHz band 2T2R mode with support of 300Mbps PHY rate Support 64QAM in 2.
Wake on WLAN via GPIO (client mode) Two printing antenna for 2.4G 4. General Specifications Form Factor PCB Dimension PCBA Height Main Chipset Crystal Frequency Wi-Fi Module 70.0mm(+/-0.2mm) x 30.0mm(+/-0.2mm) x 1.0mm(+/-0.1mm) 9.1mm(+/-0.3mm) Mediatek MT7603UNN 40MHz Host Interface Transmitter/Receiver Data Rates (kbps) Operation Voltage Operation Temperature Storage Temperature Operation Humidity Storage Humidity USB 2.
6. Pin Definition Pin Name Configuration Description 1 NC NC 2 WOW O Wake on WLAN 3 5V Power 5V power supply 4 USB_ DM I/O USB D differential minus 5 USB_ DP I/O USB D differential plus 6 Ground Ground Number NC Ground 7. Electrical Specification 6-1Absolute Maximum Ratings Symbol Minimum Typical Maximum Unit 5V power supply 4.75 5.0 5.25 V WoW GPIO input voltage -0.3 3.
7-2 Recommended Operating Conditions Symbol 5V 3.3V Parameter Minimum Typical Maximum Unit 5V power supply 4.5 5.0 5.5 V 3.3V power supply 2.97 3.63 T operating Operating temperature 0 50 V °C H operating Operating humidity 5 95 %RH VoH output high voltage 2.4 3.63 V0L output low voltage -0.28 0.
8. Current Consumption Current Consumption WLAN Tx (Dual Chain) WLAN Rx (Dual Chain) Standard Average Typ./Max. 11b 280/320 11g 265/305 11n 265/305 11b 70/100 11g 70/100 11n 70/100 Units mA Note: [1] 5V/(+/-5%) input voltage [2] The module current variation is +/-15% [3] Measure at 25°C.
9. Interface of Connector Host Interface Manufacturer: YEONHO Part Number: 12507WS-H06G WNC Part Number : 20.41250.
10.