User's Manual

Apparatus: DASH7 RF Module
FCC ID: 2ARZVWM
MODULAR TRANSMITTER INSTRUCTION MANUALS
Section of 996369 KDB D03 OEM
Manual
User’s Manual Instruction Rev 1.1
2.2 List of applicable FCC rules
This module has been approved under FCC part 15C (15.247)
2.3 Summarize the specific
operational use conditions
The module is limited to OEM installation ONLY.
The OEM integrator is responsible for ensuring that the end-user has no manual
instruction to remove or install module.
2.4 Limited module procedures
The module is for use with external antenna only. The certified antennas include:
(1) ½ Wave Antenna with maximum gain 2.2dBi (Dipole antenna)
(2) ¼ Wave Antenna with maximum gain -1.3dBi.
This module has been approved by FCC to operate with the antenna types
above with the maximum gain at at the antenna feed of 13dBm. Antenna types
not included in this list, having a gain greater than the maximum gain indicated
for that type, are strictly prohibited for use with this device.
Specially, if an antenna other than the model documented in the filing is used, a
Class 2 Permissive Change must be filed with the FCC.
2.5 Trace antenna designs
Not Applicable (No PCB antenna trace possible)
2.6 RF exposure considerations
(1) To the host product
manufacturer
IMPORTANT NOTE: To comply with FCC RF exposure compliance
requirements, the antenna used for this transmitter must not be colocated or
operating in conjunction with any other antenna or transmitter.
This equipment should be installed and operated with a minimum distance 20cm
between the radiator and your body.
2.6 RF exposure considerations
(2) To end users in their end-
product manuals
End Product User’s Manual:
The user manual for end users must include the following information in a
prominent location “IMPORTANT NOTE: To comply with FCC RF exposure
compliance requirements, the antenna used for this transmitter must not be
colocated or operating in conjunction with any other antenna or transmitter. The
equipment should be installed and operated with a minimum distance of 20cm
between the radiator and the body.”
2.7 Antennas
See 2.4 for the list of approved antennas.
Additional information:
If the end host product is equipped with an external connector, then a unique
(non-standard) antenna connector must be used on the transmitter.
A list of acceptable non-standard connectors is available upon request to
WIZZILAB.
2.8 Label and compliance
information
End Product Labeling:
When the FCC ID is not visible when the module is installed inside another
device, then the outside of the device into which the module is installed must
also display a label referring to the enclosed module. This exterior label can be
use wording ”Contains transmitter module FCC ID: 2ARZVWM” or “Contains
FCC ID: 2ARZVWM”.
2.9 Information on test modes and
additional testing requirements
If testing of the host product with this transmitter installed and operating is
necessary (to verify that the host product meets all the applicable FCC rules), a
test mode for this specific module is available upon request to WIZZILAB.
2.10 Additional testing, Part 15
Subpart B disclaimer
This module has been approved under FCC part 15C (15.247).
This modular transmitter is only FCC authorized for this specific rule part.
The host product manufacturer is responsible for compliance to any other FCC
rules that apply to the host not covered by the modular transmitter grant of
certification. (For example, Part 15 Subpart B)
Applicant for this device:
WIZZILAB SAS
29 boulevard Romain Rolland
92120 MONTROUGE - FRANCE
Yordan TABAKOV
[e-mail]
(CTO)
[phone]