INSTALLATION MANUAL T60M665 Bluetooth Modem Combo Module Ambit Microsystems Corporation國碁電子(股)公司 5F-1, 5 Hsin-An Rd., Hsinchu Science-Based Industrial Park, Hsinchu, Taiwan, R.O.C. TEL: 886-3-5784975, FAX: 886-3-5782924, Internet: http:\\www.ambit.com.tw\ 中華民國臺灣省新竹縣新竹科學園區新安路5號5樓之1 電話886-3-5784975,傳真:886-3-5782924
Contents SECTION ONE: 1.1 INTRODUCTION...........................................................................................................1 FEATURES ............................................................................................................................................. 1 1.1.1 BLUETOOTH FUNCTION............................................................................................................................ 1 1.1.2 M ODEM FUNCTION ....................................
Section One: Introduction The Bluetooth Modem Combo Module is a cost-effective wireless access. The Bluetooth circuit of this module is compliant to Bluetooth 1.1 standard. With V.92 technology, the modem part can achieve internet connection rates up to 56 kbits/s with backward compatibility. The V.92 Feature include PCM Upstream, Modem On Hold, Quick Connection and V.44 Data compression. The Audio CODEC will be placed on the notebook and contact with Modem Codec by AC-Link Interface.
current on the line exceeds approximately 130mA, and should immediately go back on hook. o The call progress signal shall be scaled digitally according to the speaker level setting (ATL1, L2, L3) o ITU-T V.92 PCM Upstream and V.90 data rates with auto-fallback to V.34, V.32terbo, V.32bis and fallbacks o TIA/EIA 602 standard for AT Command set o Supports V.42 error correction and V.44, V.42bis/MNP5 data compression o FAX capabilities: ITU-T V.17, V.29, V.27ter, V.
Section Two: Bluetooth Installation The following steps provide instructions for installing Bluetooth. 1. Make sure your MDC BT/Modem Combo card already insert into your notebook. 2. Make sure your notebook operating system support Windows 98SE or ME or 2000 or XP. 2.1 Bluetooth Installation Proceed to the following section. 1. Execute the program ‘ Setup.exe’ in the CD. Windows displays the dialog as below. Click ‘ Next’ to begin the process. Ambit Microsystems Corporation國碁電子(股)公司 5F-1, 5 Hsin-An Rd.
2.The “License Agreement” windows will pop up, please read it carefully. If you agree it, and choose ‘ I agree the terms in the license agreement’ and click on ‘ Next’ . 3. “Destination Folder” appears, specify the location of the driver and software to be installed then press ‘ Next’ bottom. Ambit Microsystems Corporation國碁電子(股)公司 5F-1, 5 Hsin-An Rd., Hsinchu Science-Based Industrial Park, Hsinchu, Taiwan, R.O.C. TEL: 886-3-5784975, FAX: 886-3-5782924, Internet: http:\\www.ambit.com.tw\ 中華民國臺灣省新竹縣新竹科學園區新
4. When all the above process are done, it will show ‘ Ready to Install the Program” window. Make sure the driver software is ready to be installed, click ‘ Install’ . Ambit Microsystems Corporation國碁電子(股)公司 5F-1, 5 Hsin-An Rd., Hsinchu Science-Based Industrial Park, Hsinchu, Taiwan, R.O.C. TEL: 886-3-5784975, FAX: 886-3-5782924, Internet: http:\\www.ambit.com.tw\ 中華民國臺灣省新竹縣新竹科學園區新安路5號5樓之1 電話886-3-5784975,傳真:886-3-5782924
5.Choose ‘ Install the software automatically [Recommened]’ , then Click ‘ Next’ to continue. 6. Congratulations! Bluetooth has been installed successfully. Please click ‘ Finish’ to confirm the completion of installation. Ambit Microsystems Corporation國碁電子(股)公司 5F-1, 5 Hsin-An Rd., Hsinchu Science-Based Industrial Park, Hsinchu, Taiwan, R.O.C. TEL: 886-3-5784975, FAX: 886-3-5782924, Internet: http:\\www.ambit.com.tw\ 中華民國臺灣省新竹縣新竹科學園區新安路5號5樓之1 電話886-3-5784975,傳真:886-3-5782924
7. Then click ‘ Finish’ to exit the InstallShield Wizard. Ambit Microsystems Corporation國碁電子(股)公司 5F-1, 5 Hsin-An Rd., Hsinchu Science-Based Industrial Park, Hsinchu, Taiwan, R.O.C. TEL: 886-3-5784975, FAX: 886-3-5782924, Internet: http:\\www.ambit.com.tw\ 中華民國臺灣省新竹縣新竹科學園區新安路5號5樓之1 電話886-3-5784975,傳真:886-3-5782924
Section Three: Modem Installation The following steps provide instructions for installing your 56K Internal modem. 1. Check the BT/modem Module already inserted into the slot. 2. Insert the connector of RJ-11 cable into the female connector of modem. The connector is keyed and will no allow incorrect insertion. Plug the other end of the RJ-11 cable into an available phone jack. 3.1 Driver Installation Your modem is using the Plug and Play (PnP) capabilities of you computer.
3 Please release your driver to “c:\driver” or any specific location you want. Ambit Microsystems Corporation國碁電子(股)公司 5F-1, 5 Hsin-An Rd., Hsinchu Science-Based Industrial Park, Hsinchu, Taiwan, R.O.C. TEL: 886-3-5784975, FAX: 886-3-5782924, Internet: http:\\www.ambit.com.tw\ 中華民國臺灣省新竹縣新竹科學園區新安路5號5樓之1 電話886-3-5784975,傳真:886-3-5782924
4. After Windows finishes loading, select My Computer\Control Panel\System\Device Manager. If you can see the modem device on this Device Manager, then you already complete the Modem Driver installation. Ambit Microsystems Corporation國碁電子(股)公司 5F-1, 5 Hsin-An Rd., Hsinchu Science-Based Industrial Park, Hsinchu, Taiwan, R.O.C. TEL: 886-3-5784975, FAX: 886-3-5782924, Internet: http:\\www.ambit.com.tw\ 中華民國臺灣省新竹縣新竹科學園區新安路5號5樓之1 電話886-3-5784975,傳真:886-3-5782924
3.2 AT Commands Basic AT Commands A summary of the commands implemented by the modem are shown in Table1. Commands may be executed when the modem is in COMMAND mode. COMMAND mode is entered upon one of the following conditions: After power up. At the termination of a connection. After the execution of a command other than dial or answer commands (ATO or AT&T). Upon the receipt of the ESCAPE SEQUENCE (three consecutive characters matching the contents of S register 2) while online mode.
E0 H0 I0 I1 I3 I4 I6 L1 L3 M1 N0 N1 P Q1 Sn? T V0 W0 W2 X0 X2 X4 Z1 &C1 &D0 Turn off command echo Initiate a hang-up sequence Report product code Report pre-computed checksum Report firmware revision, model, and interface type Report response programmed by OEM Report modem data pump model and code revision Set low speaker volume Set high speaker volume Turn speaker on during handshaking and turn speaker off while receiving carrier Turn off auto mode detection Turn on auto mode detection Force pulse dia
&K3 &K6 Enable RTS/CTS DTE/DCE flow &K4 control Enable both RTS/CTS and XON/XOFF&M0 flow control &P0 &P1 Enable XON/XOFF DTE/DCE flow control Select direct asynchronous mode Set 10 pps pulse dial with 39%/61% make/break Set 20 pps pulse dial with 39%/61% make/break Set 10 pps pulse dial with 33%/67% &P2 make/break &Q0 Select direct asynchronous mode &Q5 Modem negotiates an error corrected &Q6 Select asynchronous operation in normal link mode &R0 CTS tracks RTS (sync) or CTS is &R1 CTS is always active (
-SDR=2 -SDR=4 -SDR=6 Enable distinctive ring type 2 Enable distinctive ring type 3 Enable distinctive ring type 2 and 3 -SDR=3 -SDR=5 -SDR=7 Enable distinctive ring type 1 and 2 Enable distinctive ring type 1 and 3 Enable distinctive ring type 1, 2 and 3 %C1 \A1 \A3 Enable MNP 5 data compression Set maximum block size in MNP to 128 Set maximum block size in MNP to 256 ECC Commands %C0 \A0 \A2 \Bn Disable data compression Set maximum block size in MNP to 64 Set maximum block size in MNP to 192 Send br
Ambit Microsystems Corporation國碁電子(股)公司 5F-1, 5 Hsin-An Rd., Hsinchu Science-Based Industrial Park, Hsinchu, Taiwan, R.O.C. TEL: 886-3-5784975, FAX: 886-3-5782924, Internet: http:\\www.ambit.com.tw\ 中華民國臺灣省新竹縣新竹科學園區新安路5號5樓之1 電話886-3-5784975,傳真:886-3-5782924
S-Registers Register Function Range/units S0 Rings to auto-answer 0-255/rings S1 Ring counter 0-255/rings S2 Escape character 0-255/ASCII S3 Carriage return character 0-127/ASCII S4 Line feed character 0-127/ASCII S5 Backspace character 0-255/ASCII S6 Wait time for dial tone 2-255/s S7 Wait time for carrier 1-255/s S8 Pause time for dial delay modifier 0-255/s S9 Carrier detect response time 1-255/.1 s S10 Carrier loss disconnect time 1-255/.1 s S11 DTMF tone duration 50-255/.
Ambit Microsystems Corporation國碁電子(股)公司 5F-1, 5 Hsin-An Rd., Hsinchu Science-Based Industrial Park, Hsinchu, Taiwan, R.O.C. TEL: 886-3-5784975, FAX: 886-3-5782924, Internet: http:\\www.ambit.com.tw\ 中華民國臺灣省新竹縣新竹科學園區新安路5號5樓之1 電話886-3-5784975,傳真:886-3-5782924
Result Code Summary OK RING ERROR NO DIAL TONE NO ANSWER CONNECT 2400 CONNECT 9600 CONNECT 12000 CONNECT 19200 CONNECT 57600 CONNECT 230400 CONNECT 1200TX/75RX BLACKLISTED DATA CARRIER 1200/75 CARRIER 1200 CARRIER 4800 CARRIER 9600 CARRIER 14400 CARRIER 19200 CARRIER 24000 CARRIER 28800 CONNECT 21600 CONNECT 26400 COMPRESSION: CLASS 5 COMPRESSION: NONE PROTOCOL: LAPM CARRIER 33600 CONNECT 31200 CARRIER 34000 CARRIER 38000 CARRIER 42000 CARRIER 46000 CARRIER 50000 CARRIER 54000 CONNECT 32000 CONNECT 36000 CO
Section Four: FCC Notice 4.1 FCC Compliance This Equipment complies with Part 68 of the FCC Rules. On this equipment is a label that contains, among other information, the FCC registration number and Ringer Equivalence Number (REN) for this equipment. You must, upon request, provide this information to your telephone company. If your telephone equipment causes harm to the telephone network, the Telephone Company may discontinue your service temporarily. If posible, they will be notify in advience.
Appendix Ambit Microsystems Corporation國碁電子(股)公司 5F-1, 5 Hsin-An Rd., Hsinchu Science-Based Industrial Park, Hsinchu, Taiwan, R.O.C. TEL: 886-3-5784975, FAX: 886-3-5782924, Internet: http:\\www.ambit.com.tw\ 中華民國臺灣省新竹縣新竹科學園區新安路5號5樓之1 電話886-3-5784975,傳真:886-3-5782924
Ambit Microsystems Corporation國碁電子(股)公司 5F-1, 5 Hsin-An Rd., Hsinchu Science-Based Industrial Park, Hsinchu, Taiwan, R.O.C. TEL: 886-3-5784975, FAX: 886-3-5782924, Internet: http:\\www.ambit.com.tw\ 中華民國臺灣省新竹縣新竹科學園區新安路5號5樓之1 電話886-3-5784975,傳真:886-3-5782924
Ambit Microsystems Corporation國碁電子(股)公司 5F-1, 5 Hsin-An Rd., Hsinchu Science-Based Industrial Park, Hsinchu, Taiwan, R.O.C. TEL: 886-3-5784975, FAX: 886-3-5782924, Internet: http:\\www.ambit.com.tw\ 中華民國臺灣省新竹縣新竹科學園區新安路5號5樓之1 電話886-3-5784975,傳真:886-3-5782924