User Manual

22
z Enable SNMP Traps: Click Setup>Enable SNMP Traps to select enable or
disable SNMP Traps which are messages indicate that an action related to the
Access Point took place. You can find the messages in the right bottom
corner of the window.
z Authorization: Click Setup>Authorization.
The default code of Community is “public”. You can change the setting in
this page. Once it’s been changed, next time you’ll need to enter the new
community code to connect with the Access Point.
4.2.4 Commands menu
z Reset Device: Used to reset the Access Point. Click Commands>Reset
Device.
z Restore Defaults: Used to restore the original default values of the Access
Point. Click Commands>Restore Defaults.