User Manual

16
4.2 Configuring the Access Point
Once the connection has been completed, you can see two messages in the bottom of
the window. The one in the left indicates “Get Configuration done”; the other one in
the right display the IP address of the connected Access Point.
4.2.1 Setting the IP address of the Access Point
To set the IP address of the Access Point, follow the steps:
Step 1. Click Setup>Bridge>IP Configuration
Step 2. When Bridge IP Configuration page displays, set the new IP
address, IP Mask, and Gateway, and then click OK. If the
network uses DHCP server, simply select the check box of the
“DHCP Enable” and click OK. In DHCP network, the IP address
will be assigned automatically.
Step 3. Click File>Download Changes to save and implement the changes.
Details of each submenus are listed as follows:
4.2.2 File Menu
z Close Connection AP: Terminates the connection with the Access Point.
z Download Changes: Allows you to save any changes made for settings.
z Refresh: Used when you want to close the current connection and reconnect
to the Access Point again.