Product Information

Shenzhen LCS Compliance Testing Laboratory Ltd. FCC ID: 2AG4N-WBTWNER
This report shall not be reproduced except in full, without the written approval of Shenzhen LCS Compliance Testing Laboratory Ltd.
Page
1
of
4
FCC RF Exposure Evaluation
1. Product Information
FCC ID
2AG4N-WBTWNER
Product name
Enor E
Model number
WBTWNER
Power supply
DC Adapter Input: DC 5V, 2000mA, 10W
USB Power Input: DC 5V, 2000mA, 10W
Modulation Type
GFSK for Bluetooth V4.0(DTS)
IEEE 802.11b: DSSS (CCK, DQPSK, DBPSK)
IEEE 802.11g: OFDM (64QAM, 16QAM, QPSK, BPSK)
IEEE 802.11n: OFDM (64QAM, 16QAM, QPSK, BPSK)
Antenna Type
External Antenna
Antenna Gain
2dBi(Max.)
Hardware version
1.1
Software version
07.03.00
FCC Operation frequency
2402MHz-2480MHz
2412MHz-2462MHz
Exposure category
General population/uncontrolled environment
EUT Type
Production Unit
Device Type
Mobile Devices
2. Evaluation Method
Systems operating under the provisions of FCC 47 CFR section shall be operated in a manner that ensures that the
public is not exposed to radio frequency energy level in excess of the Commission’s guidelines.
In accordance with 47 CFR FCC Part 2 Subpart J, section 2.1091 this device has been defined as mobile device whereby
a distance of 0.2m normally can be maintained between the user and the device, and below RF Permissible Exposure
limit shall comply with.
In accordance with KDB447498D01 for Simultaneous transmission MPE test exclusion applies when the sum of the MPE
ratios for all simultaneous transmitting antennas incorporated in a host device, based on the calculated/estimated,
numerically modelled or measured field strengths or power density, is ≤ 1.0. The MPE ratio of each antenna is
determined at the minimum test separation distance required by the operating configurations and exposure conditions
of the host device, according to the ratio of field strengths or power density to MPE limit, at the test frequency. Either
the maximum peak or spatially averaged results from measurements or numerical simulations may be used to
determine the MPE ratios. Spatial averaging does not apply when MPE is estimated using simple calculations based on
far-field plane-wave equivalent conditions. The antenna installation and operating requirements for the host device
must meet the minimum test separation distances required by all antennas, in both standalone and simultaneous
transmission operations, to satisfy compliance.