Installation Manual

The Wiremold Company
In U.S.:
60 Woodlawn Street • West Hartford, CT 06133-2500
1-800-621-0049 • FAX [phone]
41019 996©1996 The Wiremold Company
Mount V2411Base to wall using two
No. 10 Pan Head screws.
Insert V2400B Base under each
tongue of V2411 Base. Mount
V2400 Base and Cover per system
instruction sheet.
V2411 Base
V2400B
V2411
Base
1
Snap V2411 cover over raceway at
corner.
NOTE: For ease of installation at corners – Cut-out any receptacle within
4" of corner. This will allow sufficient space within raceway for wire connec-
tions where two runs meet. Cut a blank raceway cover piece to fit over any
exposed area, if necessary.
V2411 Cover
3
2
V2411 90° Flat Elbow
Installation Instructions