iRespond®- UltraLite Technical Manual Wireless eSystems
Table of Contents UltraLite Base Unit -------------------------------------------------------- 1 Change the Channel --------------------------------------------------1 Adjust Power Output -------------------------------------------------1 Turn On/Off Channel Scan ----------------------------------------- 2 Setting Base UID -----------------------------------------------------2 Adjusting Base Offset ----------------------------------------------- 3 Turn on in Programming Mode --------------------------------
UltraLite/Lite Base Unit Change the Base’s Channel 1. Press the power button 2. Immediately press F1 screen. to turn on the Lite base. while Wireless eSystems scrolls across the base’s 3. When Device Address appears press ENT altered). 4. Select ENT . (This number should not be at Output Power. 5. Output Channel should now be displayed. 6. Use the up 7. Press ENT and down buttons to change the base’s channel. four more times to save and exit configuration mode. 8.
Turning Channel Scan On/Off It is best for the base and remote units to be on the same channel. However, channel scanning can be used to allow the base unit to find the best channel with the least amount of noise. To communicate with a base with channel scanning on, remote units must be configured with channel hopping on. 1. Press the power button 2. Immediately press F1 screen. to turn on the Lite base. while Wireless eSystems scrolls across the base’s 3. When Device Address appears press ENT altered).
. Use the up and down buttons to change the number. Adjusting Base Offset The Offset is the center frequency for all remote radios, ensuring base can communicate with all remotes. The Lite base’s Offset is set before it is shipped and should never be changed. 1. Press the power button to turn on the Lite base. 2. Immediately press F1 screen. while Wireless eSystems scrolls across the base’s 3. Device Address should be displayed. 4. Press ENT three times. Base will read Offset 1. 5.
UltraLite Remote Unit To Login by PIN An iRespond session must be running to login to a remote. 1. Press the power button to turn on the UltraLite remote. 2. Use the A-E Buttons to enter the correct characters of your PIN. 3. If the PIN was entered incorrectly, the right light will blink red once. 4. Renter your PIN. (If you fail to log in again, verify your PIN with the instructor) To Login Anonymously Instructor must have the iRespond session set up to allow anonymous logins. 1. Press the power 2.
FCC Non-modification statement: Changes or modifications not expressly approved by Wireless eSystems Inc. could void the user’s authority to operate this equipment. FCC Non-Modification Statement: This device complies with part 15 of the FCC Rules. Operation is subject to the following conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received. Including interference that may cause undesired operation.