Operation Manual

ManualsBrandsWIREFREE ManualsElectronicsWireless Audio Kit

1 / 3

INTRODUCTION

Connecting the WTX with Detectors.

Power on/off a WTX. Press the power button once to turn on the transmitter. Hold for 2

seconds to turn it off.

HOW TO WORK?

1, If the transmitter works with Receiver WRX

1.1 CONNECT A RECEIVER WRX. Insert the 6.35mm or 1/4” jack of the wire headphones

into the female port of WRX.

1.2 POWER ON THE TRANSMITTER.

1.3 POWER ON THE RECEIVER WRX AND PAIR IT WITH THE TRANSMITTER. Hold the

knob and turn to clockwise direction to turn it on. Keep turning to set the volume higher. Turn

it anti-clockwise direction to set the volume lower. Turn it to the end to power off.

The WRX will pair with the last transmitter automatically. Quick turn the WRX “on-off-on” to

pair a new transmitter.

SPECIFICATIONS

Technology

2.4G wireless

Audio Cable

25CM/10” straight

Audio Connector

Come with 1/4" 90° audio jack.

Customized connector available for

Garrett AT Pro ATX AT Max, White's MXSPORT

Attaching methods

Clip on rod by rubber band(included), attach to surface

by Velcro pad (included)

Transmitting distance

10meters in open area

Protection level

Splash-proof, not submersible underwater

Control

One touch button control

Indications

Battery condition and status

Dimensions

65mmx38x13mm Weight 38gram

Battery

900mAh Li-Po battery for 24Hrs continuously working

Charging time

Around 4 hours

Recharge port

USB Type-C

Transmitter WTX OPERATION MANUAL

Back Side

USB Port

Status LED

Battery Condition

Control

Rubber Band Groove

Mounting a WTX. Place the WTX on the rod and wrap

the rubber band from down side of the rod. Or use

Velcro tapes on flat surfaces such as detector control

HOLD 2

Sec

Turn on

Turn off

To Detectors

To Transmitter

Volume Up

Summary of content (3 pages)

PAGE 1
Transmitter WTX OPERATION MANUAL INTRODUCTION USB Port SPECIFICATIONS Technology 2.4G wireless Audio Cable 25CM/10” straight Audio Connector Come with 1/4" 90° audio jack.
PAGE 2
, If the transmitter WTX works with Lite Headphones 3, If the transmitter works with Pro Headphones 2.1 HEADPHONE ADJUSTMENT Before wearing the lite headphone for the first time you should adjust it properly to achieve the best sound and ambient noise attenuation. Unfold the headphone pad as the figure 1. and 2. Select the appropriate lock-in position on both sides of the headband as figure 3. The pads will adjust the angle automatically according 3.1 POWER ON THE TRANSMITTER to your head size.
PAGE 3
FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the F CC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.