User's Manual

CAUTION:Tousethisdeviceproperly,pleaseread
the user’s guide before installaon
Model:
Step1 open the back cover
Characteristic
Step 3.Replace back cover
Installing the Batteries
The RF2.4GHz optical mouse use one AA alkaline batteries.
Installing Batteries in the Mouse
Step2. Insert the batteries as shown inside the battery compartment.
Connecting the Receiver
USB Port
1.Connect the USB piug ONLY to USB port of the computer
CAUTION:To use this device properly,please read
the user’s guide before installation
Nano receiver
Instructiom Manual
RF2.4GHz Optical Mouse
Abtain the receiver on the mouse
1:when you want use the mouse,you can take out the receiver to computer by the
list step;
2:when you need stop the work or to travel, you can store the receiver on the mouse
for the moving by the list step;
1
2
Take out the receiver
Store the receiver
1
2
Dimension:L94×W58.5×H34.5mm;
Wireless optical mouse with 3 keys;
High precision optical engine;
Unique design for good handing feeling;
Self-storing nano receiver,easy to take;
2.4GHz RF transmission,up to 10m;
USB interface,Plug&Play ;
Resolution :1200DPI;
Compatible with computers of various systems and brands;
FC C STAT E MENT :
This device complies with Part 15 of the FCC Rules. Operaon is subject
to the following two condions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including
interference that may cause undesired operaon.
Warning: Changes or modificaons not expressly approved by the party
responsible for compliance could void the user's authority to operate the
equipment.
NOTE: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the F CC Rules.
These limits are designed to provide reasonable protecon against harmful
interference in a residenal installaon. This equipment generates uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instrucons, may cause harmful interference to radio
communicaons. However, there is no guarantee that interference will not
occur in a parcular installaon. If this equipment does cause harmful
interference to radio or television recepon, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separaon between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
Consult the dealer or an experienced radio/T V technician for help.
WM-709L