User's Manual

Connecting the Receiver
USB Port
Nano receiver
AAA 1.5V
Model:WM-007
FCC STAT EMENT :
This device complies with Part 15 of the FCC Rules. Operation is subject to the
ollowing two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that
may cause undesired operation.
Warning: Changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the F CC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/T V technician for help.
1. The Nano Receiver is stored inside the mouse, in the battery compartment.
To remove the receiver, open your battery compartment and remove the receiver
as per step 1.
2. Once you have finished using the mouse, remove the receiver from your USB port
and replace within the mouse housing as per step 2.
Storing the Nano Receiver
Step 1. Open the back cover.
Step 3. Replace back cover.
Installing Battery
The 2.4GHz optical mouse uses one AAA battery .
Installing Battery in the Mouse:
Step 2. Insert the battery as shown inside the battery compartment.
1. Connect the nano receiver ONLY to a USB port on your computer.
Instruction Manual
2.4GHz Wireless Mouse
Please read these instructions carefully before
first use and retain them for future reference.
Specifications:
Remove the Receiver Store the Receiver