Assembly Instructions

ManualsBrandsWinston Porter ManualsOutdoor & Patio FurnitureWallaston Rectangular 6 - Person 59'' Long Dining Set

Table Of Contents

Page 1 of 6Page 1 of 6

Caution : You must read this before you proceed

TABLE

CAUTION: This Table is NOT a TOY.

Keep your child / children at bay during the assembly

process.

For moving the Table and to prevent damage to the Table,

two adults are needed to execute this action.

Summary of content (6 pages)

PAGE 1
Caution : You must read this before you proceed TABLE CAUTION: This Table is NOT a TOY. Keep your child / children at bay during the assembly process. For moving the Table and to prevent damage to the Table, two adults are needed to execute this action.
PAGE 2
Label Picture Description QTY A Table Top 1 B Leg 4 C Leg Support 4 Label Picture Description QTY 1 Bolt (M6x50mm) 9 2 Screw (M6x35mm) 9 3 Washer 9 4 Allen Key 1 Before Beginning Assembly: Page 2 of 6
PAGE 3
OVERVIEW Table Top (A) Leg Support (C) Leg (B) FRONT FACING This Table has multiple parts and may require up to 30 minutes to assemble. To give you an overview of the Table parts, the above picture is to help you put the various parts into perspective. Please read through the instructions below to familiarise yourself with the parts and steps before assembly. Step 1 Unpack and place all parts on a clean, non-marring surface.
PAGE 4
Step 2 B 4 1 3 A Attach Leg(B) to the Table Top(A) using Bolt(①) and Washer(③) with Allen Key(④). Do not fully tighten Bolts Repeat the same process with the remaining three Legs(B) Step 3 Step 3.2 2 C B 4 4 2 A Step 3.1 Place Leg Support(C) between Table Top(A) and Leg(B), as shown above. 3.1) Secure Leg Support(C) to Table Top(A) using Screw(②) with Allen Key(④) 3.
PAGE 5
Step 4 Turn the Table over, with assistance from your partner. EXERT pressure, floorwards, onto the Table. This pressure will help the Legs and Table Top reach alignment at all joints. Check for wobbles. In a sequential manner, gradually tighten all Bolts and Screws until evenly secured. When tightening the Bolts and Screws tighten sequentially. Do not tighten any Bolt or Screw fully and then move towards the next one. This could cause the frame to warp.
PAGE 6
Page 6 of 6