User's Manual

User Manual
1.1 Battery Installation
⑴.Open the battery cover on bottom of mouse, and pull out the Nano receiver.
⑵.Put battery in according to the polarity of the battery, then close the cover.
2.2 Device connection:
⑴. Put Nano receiver into the computer's USB port, and ensure good contact。
⑵. Computer will recognize a USB mouse device.(can be seen from the devicemanager)
⑶.Turn ON/OFF button (on the bottom of mouse) to “ON” for power on (“OFF” button for
power off); there red right on bottom that enter the working state.
⑷. Moving the mouse, you can enjoy wireless freedom.
⑸. If the connection failed，connection methods as follows：
Turn ON/OFF button to ON, and re-install battery, then replu Nano receiver;Mouse
can be work normally.
3.3. Sleeping mode:
Press any button to wake-up from Sleeping mode
4.4. receiver collection function:
⑴.For convenient to carry, can put Nano receiver into the collection tank of mouse.
5.5 Environment condition:
⑴.Operation temperature:0 ℃～50℃，humidity:20％RH～90％RH without condensations.
6.6 Matters needing attention:
⑴.Applications of the mouse will be affected on the rough or reflection surface.
⑵.Don’t disassemble mouse and receiver
⑶.Use dry and soft cotton product clean mouse.
⑷.Careful choice battery. its quality affects operation time and mouse life.
Instructions on “wireless”
Transmission frequency is 2.4GHz,it meet R&TTE Directive 1999/5/EC noun in Europe and
its radiation does not harm human body .(far less than the mobile phone’s radiation)
Instructions on battery
Don’t throw the waste battery into recycle bin while replace battery.