UHF RFID Reader Module UHF RFID Reader Module HYM360 Winnix Technologies Co.
UHF RFID Reader Module Brief Introduction HYM360 UHF Reader Module complied with EPC C1G2 Protocol, its working frequency is 902.75-927.25MHz, with standard 2dBi antenna, the reading distance can reach 2 meters. With low power consumption, simple power supply and interface circuit, a high-performance and cost-effective RFID system can be established. It is suitable for retail，access control, medical industry, food tracking, anti-counterfeit and so on, especially for small size hand-held UHF RFID reader.
UHF RFID Reader Module Requirement on Antenna Product Features Electrical Properties: It is a general antenna for UHF RFID applications with high gain and low VSWR. Mechanical Properties: The compact and artistic antenna is suitable for all kinds of severe environment for its dual waterproof design with Gasket and silicone and strengthening rib of shell. Performance Specifications Frequency Range:860MHz～960MHz Maximum VSWR: ≤1.
UHF RFID Reader Module Installation guide HYN503 antenna can be installed on steal framed structure or bracket by own antenna bracket, and connect with reader with coaxial line. The antenna can be installed horizontally or vertically, it is decided by installation location, the angle can be adjusted after installation according to the real environment. Antenna bracket is an optional accessory, you can choose according to your special requirement. 1.
UHF Antenna 1 2 3 M6 screw, elastic washer and plain h Dog tooth M6 U style screw bolt Figure 4. The structure for the Step 2 in the first case 2.2 Vertical Installation Step 1：Use M6 screw, elastic washer and plain washer, to fix the L board on the antenna, as shown in Figure 5.
UHF RFID Reader Module 1 2 3 M6 screw, elastic washer and plain washer Dog tooth M6 U style screw bolt Figure 6 The structure for the Step 2 in the second case 6/9
UHF RFID Reader Module Appearance and Structure Drawing 1 Size of Reader Module Interface Definition PIN Signal Name Signal Direction Function/Compatibility Description 1~2 NC 3~6 GND - Module Connecting Ground 7 VDD Input Module Supplying power 8 EN Input Module Enabling, 9 GPIO Output 10 GPIO Output 11 UART_RX Input 12 UART_TX Output 13~16 GND - Module connecting ground 17 RFOUT Bidirection Module Radio frequency Input and output interface 18~24 GND - Module con
UHF RFID Reader Module Environment Requirement No. 1 2 3 Item Working temperature Storage temperature Relative humidity Technical Data Unit -20～+70 ℃ -40～+85 ℃ 10%～90% RH Remark Circuit for Reference Drawing 2 Circuit for reference Warning This device complies with Part 15 of the FCC Rules.
UHF RFID Reader Module NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
