User's Manual

First step: Bluetooth pairing
Touch-hold the camera key for 3 seconds till the
blue light flashes to show that the Bluetooth is
turned on: pair up with“Dispho”and the blue light
will be on all the time if the pairing is successful.
Touch-hold the camera key for another 3 seconds
to shut Bluetooth down.
Second step: open the phone holder
Set this product face up and turn the phone holder
in the back downward for 90° to open it. Then
rotate the holder 180°horizont
ally to face forward.
Third Step: Fix the phone
Rotate the phone holder till you can pull open the
holder handle and fix the phone securely on the holder.
Fifth Step: Use tripod
This product comes with a tripod. Open the selfie
holder from the bottom and fix it on a steady
horizontal plane, then you can start to enjoy your
selfie shooting experience.
Separated Bluetooth remote control is designed to be
separable with a Bluetooth range of 10 meters.
The bo
ttom of the remote control is equipped with a charging
port; please use it to charge this product.
Fourth Step: Photograph
Set the volume button on your phone to act as the
shutter button.
Use the remote control to take a photo.
Camera button
Quick Start Guide
Product name ：Tripod Selfie Stick
Model：WS-SQB645B
Executive Standard：Q/YDS001-2015
CAUTION
RISK OF EXPLOSION IF BATTERY IS REPLACED
BY AN INCORRECT TYPE.
DISPOSE OF USED BATTERIES ACCORDING
TO THE INSTRUCTIONS
Winners' Sun Plastic & Electronics (Shenzhen) Co., Ltd.
Building E, Yingtai Industrial Zone, Longhua New District,
Shenzhen,China.
changes or modifications not expressly approved
by the party responsible for compliance could void
the user’s authority to operate the equipment.
This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection
against harmful interference in a residential
installation. This equipment generates, uses and
can ra
diate radio frequency energy and, if not
installed and used in accordance with the instructions,
may cause harmful interference to radio communications.
However, there is no guarantee that interference
will not occur in a particular installation.
If this equipment does cause harmful interference
to radio or television reception, which can be
determined by turning the equipment off and on,
the user is encouraged to try to correct the
interference by one or mor
e of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment
and receiver.
-- Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV
technician for help.
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.