(WR02/WT02) Quick Start Guide WR/ WT Full User Manual Rev 1.
Introduction 1. Modular design to assemble for Extender, Splitter, Matrix and Switcher for up to 15x15 applications. 2. Extends 4K 30P, 1080 60P HDMI signal up to 180m (600ft) over a single Cat5E cable, 100M Ethernet. 3. Use conventional Ethernet L2 Switch for extension and distribution, and can be cascaded by the L2 Ethernet switches for longer distance. 3. Supports IR (20KHz~60KHz) extension and RS232 extension over IP. 4. Supports Stereo Audio over IP, independent to HDMI extension. 5.
Hardware Overview for WR 1 2 3 4 5 6 7 RJ45 DC IN 8 RST HDMI OUT AUX OUT 9 10 11 12 13 14 15 PWR LINK STA MODE 16 12ID1 IR IN USB K/M RS232 17 18 248 S WSP 1. DC IN port: 12V/1A power supply is required. 2. HDMI OUT port: Connect to the monitor for display. 3. AUX OUT port: Output audio to the speaker connected. Note that HDMI OUT port receives audio signal simultaneously. 4. IR IN port: Input IR signal for remote control. 5.
Hardware Overview for WT 1 2 3 4 5 HDMI IN AUX IN IR OUT 6 7 8 RJ45 DC IN 9 HDMI OUT 10 11 12 13 14 15 16 RST PWR LINK STA MODE 17 12ID1 24 USB PC RS232 18 19 8 S WSP 1. DC IN port: 12V/1A power supply is required. 2. HDMI OUT port: Connect to the monitor for loopback. 3. HDMI IN port: Connect to your device (laptop or computer). 4. AUX IN port: Input audio to replace that from HDMI source. 5. IR OUT port: Output IR signal for remote control. 6.
Hardware Installation for WR/ WT 1. Position the toggle switch to the same mode (SW/SP) on both WR and WT. 2. Connect power to 12V/1A and a monitor to display output on WR. 3. Connect WR and WT by the HDMI cable to pair. The STA signals keep flashing until pairing completed. 4. After pairing, connect power to 12V/1A, a monitor for loopback, and a device to input on WT. 5. For SW mode, please set WR and WT to the same channel ID. Every WT under the same network should be set to different channel ID.
Channel Adjustment Click ID button to switch channel from 1 to 15. For setting channels above 16, please refer to full user manual.
FCC Caution: Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: —Reorient or relocate the receiving antenna. —Increase the separation between the equipment and receiver.