Installation manual

ManualsBrandsWinegard ManualsTV AntennaRoadTrip Mission

RoadTrip

Digital Satellite Mobile TV Antenna for Two Receivers

RoadTrip

SD - Stationary Satellite TV Antenna

RoadTrip

SDi - In-Motion Satellite TV Antenna

INSTALLATION MANUAL

Winegard Company • 3000 Kirkwood St. • Burlington, IA 52601-2000

319/754-0600 • FAX 319/754-0787 • www.winegard.com

WINEGARD

Summary of content (8 pages)

PAGE 1
WINEGARD® RoadTrip® Digital Satellite Mobile TV Antenna for Two Receivers RoadTrip® SD - Stationary Satellite TV Antenna RoadTrip® SDi - In-Motion Satellite TV Antenna INSTALLATION MANUAL Winegard Company • 3000 Kirkwood St. • Burlington, IA 52601-2000 319/754-0600 • FAX 319/754-0787 • www.winegard.com Printed in U.S.A.
PAGE 2
Parts Included • Tools Needed • How to Unpack The Winegard RoadTrip® antenna is designed specifically for use with motorized recreational vehicles. Winegard recommends using a qualified installer familiar with RV structures and wiring to ensure proper installation and to prevent damage to the RV or satellite dish.
PAGE 3
Installation Diagram CENTER LINE OF THE VEHICLE SIDES OF CONTROL UNIT MUST BE PARALLEL TO THE CENTER LINE OF THE VEHICLE AND FACE FRONT OR REAR OF VEHICLE. Control Unit LNBF GPS CABLE (RoadTrip SDi In-Motion models ONLY) ELEVATION MOTOR CENTER LINE OF THE VEHICLE GPS ANTENNA (RoadTrip SDi In-Motion models ONLY) Rev.
PAGE 4
Quick Reference Guide Your Winegard RoadTrip® satellite TV antenna has been designed to be the most userfriendly Mobile Satellite Antenna on the market today. Upon installation of the antenna, or after changing satellite service provider, simply set the switches inside of the dome to the settings shown in the Operation manual. These switches enable the dish to locate the proper satellite for your service provider.
PAGE 5
Installation Installing unit on roof of vehicle — Install in DRY conditions only! ! 6. Place the unit on the roof in its permanent location and mark around each base foot, Figure 4. IMPORTANT! Do not install this system in the rain, or under any wet conditions. Moisture may affect electronics and void your warranty! FIGURE 4 1. For best performance and to reduce signal acquisition time, park vehicle on a level surface; level the RV. 2. Select a level spot on your roof for installation.
PAGE 6
Installation INSTALLING THE POWER SWITCH GPS installation — RoadTrip® SDi (for in-motion) only 1. Choose a location to install the RoadTrip power ON/OFF switch. Remember when selecting a location that you will need to run the +12VDC power cable from the RoadTrip antenna to the switch. Be sure the switch is in the OFF position before continuing. See Figure 7 page 6. 10. The GPS antenna is pre-wired and has a 1 meter cable running through one of the connectors. Determine location for GPS antenna.
PAGE 7
Installation • Wiring • Specifications Connecting the receiver — ! To order receivers or programming please call the Winegard receiver hotline: 1-(866) 609-9374. Your RoadTrip® antenna has now been successfully installed. Proceed to the Operation Manual for RoadTrip antenna setup and for Operation Instructions. Connecting one receiver 1. Connect the coax cable from the antenna to the “SATELLITE IN” on the receiver. 2. See page 5 of Operation Manual for receiver set-up. Connecting two receivers 1.
PAGE 8
WINEGARD MOBILE PRODUCTS LIMITED WARRANTY (2 YEARS PARTS; 1 YEAR LABOR) Winegard Company warrants this product against defects in materials or workmanship for a period of two (2) years from the date of original purchase. During year one (1) of such warranty, Winegard Company will also pay authorized labor costs to an authorized Winegard dealer to repair or replace defective products.