Instruction Manual www.winegard.com/pathway For receivers and programming, call 1-866-593-0348 For up-to-date information on receiver compatibility and programming, visit www.winegard.com/receivers For help, email help@winegard.
Quick Setup for One Receiver Compatible Receivers 1. Make sure the Pathway® X1 antenna is in a location with a clear view of the southern sky. 2. Connect the primary receiver to the “MAIN” port on the base. The Pathway X1 antenna must be used with DISH Solo HD receivers. Examples of DISH Solo HD receivers include DISH Wally, 211z, 211k, 211, and 411 receivers. 3. After connecting the receiver to a power source, complete receiver setup. Select the state that you are currently in.
Warnings ! Do not place the unit in water greater than one inch deep, or water may damage the electronics. ! Do not install or operate the antenna in winds of 35 mph or greater. The antenna will roll in winds ≥35 mph. ! Care should be taken when transporting and setting up the antenna. Do not toss or drop the antenna. ! Do not paint the antenna. Painting the antenna may cause signal degradation and will void your warranty. ! The antenna is not meant for use with the Carryout® ladder mount.
. Receiver Setup for a New Wally Receiver The antenna may make a slight grinding sound when searching for satellites; this is normal and does not harm the unit. ® If using a new Wally receiver with the Pathway® X1 antenna, the receiver will go through an Installation Wizard to help with the setup process. Follow the on-screen instructions to program the remote control. Step 1 of the Installation Wizard will pair the remote to the receiver.
Updating Receiver Software For optimal performance, update receiver software occasionally. To allow the software to update, leave the satellite on signal, and press the Power button on the remote or front panel of the receiver; this will put the receiver in Standby mode (figure 7). Do not unplug the receiver at this time. Select the state of your current location, and then select “Scan” to begin the search routine (figure 9).
Setup for a Secondary Receiver Press “Test Installation 5” to start the Check Switch test (figure 15). After completing the setup on the main receiver, power on the secondary receiver. If using a new receiver, you will be guided through the setup by the Installation Wizard; follow the on-screen steps to complete the setup. If using a receiver that is currently active or has been used previously, you will need to complete the setup by doing a Check Switch test.
Operation of Secondary Receiver FCC Guidelines When using a secondary receiver with the Pathway® X1 antenna, the secondary receiver does not have the full function of the primary receiver. The primary receiver will determine which satellite is viewed, and the secondary receiver will need to be set up for that satellite. If the primary receiver changes to a channel on a different satellite, the secondary receiver will lose reception and need to complete setup again on the new satellite.
Troubleshooting On Screen Possible Cause Mobile Antenna Setup does not appear Solution • No communication between receiver and satellite dish • Check wiring. Verify connection to Main port. Verify good coax. • Receiver software not compatible • Ensure a compatible DISH® Solo HD receiver is being used. • Connect receiver to fixed/home satellite dish for software update.