Instruction Manual www.winegard.com/carryout For receivers and programming, call 1-866-609-9374 SD SD/HD SD/HD For up-to-date information on receiver compatibility and programming, visit www.winegard.com/receivers For help, email help@winegard.
Specifications Compatible with DIRECTV®, DISH®, & Bell TV™ programming Supports up to two receivers For stationary use only Includes 25’ coaxial cable, 3’ coaxial cable, and power inserter Unit weight: 10 lbs Unit height (no feet): 13.5" NOTE DIRECTV Sat. 119° Dome Base Eyelet Handle Diameter: 14.3" Elevation range: 18–65° Azimuth: 0–416° UV-protected plastic dome Operating temperature specifications: -25° to 70° C (-13° to 158°F) Compatible Receivers Receiver models change frequently.
. Choosing a Location Warnings ! Do not place the unit in water greater than one inch deep, or water may damage the electronics. 1. Choose a location with a clear, unobstructed view of the southern sky. Avoid obstructions such as trees, hills, vehicles, or buildings—these can block the signal from the satellite. ! Do not install or operate the antenna in winds of 35 mph or greater. The antenna will roll in winds ≥35 mph. NOTE Satellite signal will not pass through solid objects.
5. Receiver Setup 5. Select 3-LNB (18”x 20”) or 3 Satellites. If given the option of SWM or Multiswitch, select Multiswitch. Connect the receiver to a power source, and complete receiver setup. Receiver setup for the primary receiver follows; if your receiver differs from the options shown, you may need to consult your receiver manual. The wording and display used in your receiver may differ slightly. Check out online receiver setup guides for your antenna at www.winegard.com/receivers/setupguide.php.
DISH Receiver Setup 5. Select Check Switch. If using two DISH receivers with the Carryout G2+ antenna, both receivers must be configured off of the primary port by following the steps below. 1. Disconnect coax cable from the Satellite In port on the back of the receiver. Satellite In port Back of 211z receiver shown 2. Press Menu on your remote. Select option 6, System Setup. 6. Select Test. It will go through a number of steps, then return to the screen shown here with previous information cleared.
Troubleshooting Issue Possible Cause Solution Vin indicator unlit on power inserter • No DC power into power inserter • Ensure power adapter is plugged into outlet and that outlet is providing AC power • Ensure power adapter is connected to power inserter Receiver indicator unlit on power inserter • No communication between receiver and power inserter • Ensure 3’ coaxial cable between receiver and power inserter’s RECEIVER port is properly connected • For DIRECTV users, ensure receiver is compatible
Using Outside Receptacle Optional Accessories If your outside TV receptacle is wired for satellite, you’ll need to locate where that receptacle leads and connect that directly to your satellite receiver. MT-4000 Ladder Mount If the outside TV receptacle is wired for cable, the wiring will have to be modified for use with satellite. The coaxial cable cannot run through any other devices or switches before the satellite receiver.
WINEGARD MOBILE PRODUCTS LIMITED WARRANTY (2 YEARS PARTS; 1 YEAR LABOR) Winegard Company warrants this product against defects in materials or workmanship for a period of two (2) years from the date of original purchase. During year one (1) of such warranty, Winegard Company will also pay authorized labor costs to an authorized Winegard dealer to repair or replace defective products.