60 Kurve Indoor Wi-Fi Smart Ceiling Fan WR1804 SERIES 0.26 14.77 66 2221 0.39 32.37 102 3861 0.56 66.82 150 5940 7.75 9.65 17.05 21.23 3.
Decorative light kit plate (1) 14 11. 12.
Pay attention to the arrow label on the motor assembly . Please start from this arrow when you align 2 holes from the blade to the fan motor assembly. Secure the blade with two blades screws and two metal washers. Metal washer FIG.
Step 2. Loosen the two set screws from the fan motor assembly coupling. Remove the hitch pin and lock pin from the fan motor assembly. (Fig. 7) Step 3. Remove the hanger ball from the downrod by loosening the hanger ball set screw, and removing the cross pin, then sliding the hanger ball off of the downrod. (Fig. 7) Step 4. Carefully feed the fan wires up through the downrod. Thread the downrod into the fan motor assembly coupling. Line up the holes and replace the lock pin and the hitch pin.
Step 1. Insert the receiver into the mounting bracket with the flat side of the receiver facing the ceiling. (Fig.9) Step 2. Follow the steps below to connect the fan to your house supply wires. Secure the wire nuts supplied with your fan by wrapping the connections with electrical tape. (Fig.10) Motor to receiver electrical connections: ● Connect the black wire from the fan to the black wire marked "TO MOTOR L" from the receiver.
Step 1. Remove 1 of 3 screws from the mounting ring and loosen the other 2 screws. (Do not remove.) (Fig.12) Step 2. Place the key holes from the decorative light kit plate over the 2 screws previously loosened from the mounting ring, turn the decorative light kit plate until it locks in place at the narrow section of the key holes. Secure by tightening the 2 screws previously loosened and the one previously removed. (Fig.
Programming the remote Set code labeled "ON" means "it is only on/off, NO DIM".
Operating the transmitter The Reverse switch is located on fan motor assembly (Fig.16). Slide the switch to the Left for warm weather operation. Slide the switch to the Right for cool weather operation. NOTE: Wait for fan to stop before changing the setting of the slide switch. REVERSE SWITCH FIG. 16 FIG. 18 FIG.
Connect your smart fan to BOND After testing all operations of the ceiling fan and remote control, you are now ready to connect your smart fan to the BOND HOME APP. Download the BOND HOME APP using the Google Play or Apple Play Store and follow the prompts given.
10