Wind IOT Product Manual Mode No: H1 1
Table of Contents I. Overview .............................................................................................................................................................3 1.1 Product Introduction ..........................................................................................................................3 1.2 IOT functions and principles............................................................................................................3 2. Basic parameters ............
1. Overview 1.1 Product Introduction IOT controller, the vehicle assembly controller. It is the core control component of the entire scooter. It collects the throttle button signal, the vehicle GPS positioning signal and other component signals, and makes corresponding judgments to control the movement of the lower components and drive the scooter to run normally.
each system must also cooperate with each other to optimize matching. Therefore, electric scooters require a complete vehicle controller to manage the various components. The electric scooter uses the IOT controller as the main node to manage, coordinate and monitor all aspects of the electric scooter through the internal wiring harness to improve the energy utilization rate of the vehicle and ensure the safety and reliability of the vehicle.
2. Basic parameters 2.1 Communication parameters Mobile Communications: European version: FDD/TDD/WCDWA, US version: FDD LTE/WCDMA Positioning communication: Use U-blox and turn on GPS/GLONASS/GALILEO/QZSS Bluetooth communication: BLE4.0 2.2 working environment Working Voltage：Range DC15V-55V, Normal power supply DC 36V Working power: 0.6w Working temperature: -20 °~ 70 ° Protection level: IP67 Appearance size: 93 (L) * 67 (W) * 52 (H) mm 3. Interface function definition 3.
3.2 Front View of the Interface 3.
4. Dimensions 4.1 Shape 4.
5. Control system 5.1 The control interface of the system is inside the shell. It is an interface with 8 frames. It can be programmed and read and written by opening the shell connection interface. Serial port section Features 1 2 3 4 5 6 7 8 3V3 G Burnsck BurnDIO blank G MCU-TX MCU-RX 6. Installation Notes 6.
7.7 remote upgrade function 7.8 smart battery monitoring function The intelligent battery management system constantly monitors the working status of each battery and sets multiple protections, such as discharge protection/low temperature protection, to ensure the safety of the battery and prolong its service life. 7.9 low battery protection 8. System maintenance and inspection 8.1 Although the device is fully sealed and waterproof, it is not possible to flush the IOT controller with water.
interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
The antennas used for the transmitter must be installed to provide a separation distance of at least 20cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter 11
